I can rotate engine by hand but when I do timing chain wo...

The starter on your vehicle is causing your problem. The starter is spinning but the starter lever is not allowing the starter solenoid bendix to engage the flywheel and turn the engine. Technical Service Bulletin (TSB) 13-EE-001 dated January 2013...

The anti-theft system in your vehicle will prevent the computer from delivering fuel and spark to the engine if it does not recognize the chip inside your key. Your specific vehicle also requires a minimum of 2 keys programmed to...

Hi there. From the description you have provided, the knocking noise in your engine is serious. The engine oil light coming on while driving down the highway, then quit running is equally concerning. Assuming you have had the engine's oil...

The idle air control valve monitors the air intake as it is mixed with fuel prior to being injected into the engine. This valve is controlled by the vehicle's computer which will adjust idle speed based upon other measurements such...

There is not a fuse for the water pump, however this may be caused by a faulty coolant fan switch or potentially a faulty coolant temperature sensor which is responsible for relaying the coolant temperature to the computer which then...

This may be related to many different possibilities, some of which may be related to a lack of spark and some of which may be related to a fuel delivery problem or a combination of both. For example, if the...

Hi there. The wastegate actuator is not functioning correctly or the boost sensor (https://www.yourmechanic.com/services/barometric-sensor-replacement) is not working making the turbo boost properly. Check the wastegate actuator hose (https://www.yourmechanic.com/services/wastegate-hose-replacement) and see if its broken and listen for leaks when you drive...

Hello there. If the engine does not crank over, the issue is probably the starter, starter relay or ignition relay. If the engine does crank over, then it is likely that your Crown Victoria is experiencing an ignition or fuel...

There is no average cost of a tune up because such a service is no longer specified in the Factory Service Manual. Tune-up is a term that was mainly used decades ago when carburetors existed and ignition system distributors required...