Q: Clunk

First, I want to say thank you for providing the great amount of information regarding your Acura. From the information provided, I believe the concern you are experiencing with your TL is caused by the the front tires being out...

Hi. The lights you are mentioning have been caused by loose or corroded battery terminals. The symptoms you are experiencing sound like an engine component position sensor. The engine's computer relies on the values from the crankshaft and camshaft position...

Hello. If the car is overheating severely, the heads and/or block will warp and the engine will have to be rebuilt. Best not to drive it if you know it is overheating. If you are continually replacing coolant but it...

The starter on the truck may have burned out from the repeated jumping of the weak battery. This will cause the voltage to the starter to be low and overheat the starter when you try to turn it over multiple...

Hello, thanks for writing in. This problem could be either an engine thermostat (https://www.yourmechanic.com/services/thermostat-replacement) that is not keeping the engine at a constant running temperature (temp gauge steady in the center), or the heater control valve (https://www.yourmechanic.com/services/heater-control-valve-replacement) or controls are...

Hi there - I believe your brake light switch (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-brake-light-switch) is either sticking or mis-adjusted, resulting in the brake lights remaining on after the brakes are used. Turning the ignition switch to the "Off" position removes power to that circuit,...

The tensioner on your vehicle should move more than this. You need to start by checking the drive belt routing. If the belt is not routed right then it will appear that the tensioner is not moving enough. If the...

Hello, thank you for writing in. The vehicle may be having issues with the electric power steering module and system. Luckily there is a check engine light on, which means there is an engine diagnostic code that has been set....

Hello - according to Chrysler (Owners Manual - Pg. 597, if you have the 2.4 liter 4 cylinder, the correct oil is 0W20 weight. If you have the 3.6 liter V6, the correct weight is 5W20. Pennzoil (R) or Shell...