Skip the auto shop - Our mechanics make house calls

Q: Clutch sticking

asked by on

My clutch is sticking.

A: The clutch hydraulic system would have to b...

The clutch hydraulic system would have to be checked first, to make sure that it is moving the clutch pressure plate in and out. If it is working properly, then your clutch pressure plate has a problem, and the transmission would need to come out in order to diagnose the clutch pressure plate, and clutch plate. If the hydraulic system is not moving the clutch pressure place, then it would need to be checked for problems like the master, or slave cylinders binding. I recommend that you have a mechanic, like ones from YourMechanic, come by and check your car to isolate the cause of your clutch problem.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: I need help with diagnostic trouble codes that suddenly appeared making vehicle almost undriveable.

Firstly, you should have the battery disconnected and the PCM disconnected. Check their connectors for any problems and apply dielectric lube to the connectors so the connection is clean from corrosion. If the problem continues then replace the PCM. All...

Q: Loud noise from under valve cover

With this symptom, you will likely need to check your oil level. If the oil level is okay, you may have internal engine problems, which need to be inspected further. If you would like to have this inspected, a certified...

Q: How far can I drive with my Battery Light (including my brake lamp) turning off a minute ago. I am aware my brake pads are gone

The usual cause for a battery light to come on is a fault in the charging system. If the alternator is not charging and providing electrical power, then the electrical system will resort to draining the battery for power. Since...

Related articles

How Long Does a Heater Control Valve Last?
Keeping the right amount of coolant in a car is essential in keeping the engine at the right temperature. Failing to have the right amount of coolant or even bad elements...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.