Q: Noise

Based upon your description, it appears you have a refrigerant leak. If you have inserted refrigerant that has 'UV Dye' included, detecting the leak is helpful with a 'UV light'. There are four major components linked together with hoses and...

Hello! Believe it or not, that has been done several times before on Subarus. The transmission drain looks very similar to the oil drain, so they can easily be mistaken for one another. Usually, the transmission will just have to...

Hello there, thank you for asking about your 2010 Hyundai Genesis Coupe. The service manual calls for the oil and filter to be changed every 3000 miles. If you would like help changing your oil and filter (https://www.yourmechanic.com/services/change-oil-and-filter), have a...

There are many possible causes for this symptom; there could be a vacuum leak, or the car may simply need a tune-up. It would probably be best to have a certified mechanic take a look at the car and perform...

Hi - yes, it is dangerous to continue driving with a "steering assist malfunction (https://www.yourmechanic.com/article/what-does-the-attention-assist-warning-light-mean-by-spencer-cates)" message showing. Many cars now utilize electrically assisted power steering. The loss of steering "assist" can also cause binding of the steering assembly, creating a...

Hi There, As you may know, these lights are designed to come on at specific mileage intervals that are preset by the factory. When your mileage exceeds a certain amount relative to the last oil change (https://www.yourmechanic.com/services/change-oil-and-filter), this will trigger...

I am imagining that your driveway is on a steep hill and you are backing out uphill. If that is the case, I would expect that you would have to step on the gas to make the car go backwards....

You may have a problem with the crankshaft sensor and it was damaged when you replaced the pulley. Have the computer scanned for codes and see if getting a rpm signal from the sensor. Replace the sensor requires removing the...

When the check engine light comes on, it means the controller has detected a fault in the engine management system. At this time, trouble codes are stored that can help lead you to the malfunction. These codes can be read...