Q: Car stuck in limp mode

asked by on February 11, 2016

My car is stuck in limp mode.

Shift Interlock Solenoid Replacement $96.05 - $1115.92 Get a Quote
Transmission Fluid Service $125.08 - $445.00 Get a Quote

It sounds like one of the shift solenoids is not functioning properly. I would recommend having a technician come out from YourMechanic and pull the codes on the computer, replace the shift solenoid, and change the transmission filter and fluid.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

Ford Focus DPS6 transmission - Are the actuators located inside the TCM? 2013 Ford Focus

Hello - the clutch actuators are external, but bolted to, the transmission. There are 2 "shift drums", activated by clock motors, inside the Transmission Control Module (TCM) which do the actual gear selection. Ford seems to like to refer to...

How do I bypass the PAT system? Or how do I bypass the anti-theft command controlled by the PCM?

The PATS system cannot be bypassed. You are required to have a coded PATS ignition key in order for the computer to turn on the spark and fuel to the engine. If you do not have a PATS programmed key...

Had the tires rotated and now there is a slight jerkiness in the steering at low speed during turns.

I believe your problem is as simple as having your tires re-balanced and having an alignment done on your car. I wouldn't go too far in depth with this issue at this point because it doesn't seem too serious at...

My car won't start after replacing transmission

It will be hard to tell if a Check Engine Light code has popped up since the car won't run, but you can still hook up a code reader to see if there are any faults. Any codes present may...

What should I know about the cabin air filter?

Your engine has an air filter, and it serves to protect the engine of the car from damaging dust, pollen and debris. Your car’s Air Conditioning system also has a filter – called a cabin filter. It serves the same...

My car is C180 AMG. My car jerks but when i unplug the airflow meter sensor it drives normal, its a new airflow meter.

Hello there, many different faults can cause the MAF sensor on your 1999 C180 to cause the car to run poorly. If the MAF sensor was replaced and the problem still remains than the most likely faults are a vacuum...

Despite repairs, vibrations and droning noise persist - 1997 Ford Aerostar

Hello. With the information I have, it sounds like there could be an issue with the rear differential of your van. A droning noise from the rear could be caused by one of the wheel bearings, or the carrier bearings...

It won't start and the ECU is not found by scanner.

Hi there. First check the battery and make sure that there is 12.6 volts. If the battery is low, then the battery will need charged before testing again. Check the wiring from the battery to the fuse box and make...

1993 Ford F150 4.9 straight 6 fuel pump keeps running, won't start, replaced relay and fuel pressure regulator, still having the same problem

Hi, thanks for writing in. You need to have the fuel pressure checked to see if the pressure is low. The fuel pump inlet screen may be getting clogged causing the pressure to drop off but the pump will continue...

Related articles

The Top 5 Selling Cars in Arizona in 2012
Depending Depending on where you live in Arizona, the weather is either arid or there may be periods of heavy snow – such as in the mountain areas. The vehicles that have been popular in previous years for the area,...
The Best Used Cars to Buy If You’re a Painter
If If you’re a painter, and you work for someone else, chances are you don’t care all that much about what you drive, as long as it gets you to and from work reliably. On the other hand, if you...
How to Buy a Good Quality Positive Crankcase Ventilation (PCV) Valve
The The positive crankcase ventilation (PCV) helps create the division of emission-control devices; it routes the leftover combustion gases from the bottom of the engine and the oil pan back into the crankcase where instead of escaping into the atmosphere...