Q: Can I get a diagram of where my camshaft position sensor is located and a guide in replacing it

The first thing that would need to be checked is where the oil leaks are and if the oil is leaking onto the clutch causing a chatter in the clutch or you are feeling a misfire in the engine from...

Hello there. Many different faults can cause the vehicle to jerk and have acceleration issue. The most likely cause of these are spark plugs (https://www.yourmechanic.com/services/spark-plugs-replacement), battery (https://www.yourmechanic.com/services/battery-replacement), alternator (https://www.yourmechanic.com/services/alternator-replacement), fuel pump (https://www.yourmechanic.com/services/fuel-pump-replacement), low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service), MAF sensor (https://www.yourmechanic.com/services/mass-airflow-sensor-replacement), vacuum...

You may need to have the key re-flashed to the car's computer. It sounds like every time you leave the car it has a problem re-associating itself with the car. I would recommend taking it back to the Chevy dealer...

Your computer is located inside the car and would need to be tested by scanning the computer to see if it is storing fault codes (https://www.yourmechanic.com/article/how-to-read-and-understand-check-engine-light-codes-by-jason-unrau) for an internal problem or an indication to some engine sensors that may have...

Hello. Grinding noises from a wheel are usually the result of worn brakes or wheel bearings. If the noise began after hitting a pot hole, then it may be possible that the wheel bearing was damaged form the impact. The...

Hello. If your monitors are showing not ready, then that is because the computer was recently reset or the battery may have been replaced. If either of these occurred, then there is a specific amount of driving that needs to...

Hi there. The slip indicator light could be on for a numerous items. The main items that is causing your rpm's to fluctuate are the camshaft position sensor (CPS) and the idle air control valve (IAC). The CPS will cause...

Hitting a pothole can damage wheel bearings. Basically, the force of the impact causes the ball bearings to get driven into the bearing race and cause indentations in the race. Then the bearing eventually becomes noisy. You could have damaged...

If the engine has a leaking water pump or stuck thermostat or other leaks and engine was ran until the temperature went all the way to hot then it may have damaged the engine cylinder head gasket and head and...