Q: 1998 Ford Ranger 2.5L stalling when put into drive.

asked by on

My truck stalls when put into drive. It is throwing codes. Codes are P0743, P0750, P0755, P0760, P0320. I've changed the MAF Sensor, IAC SENSOR, TPS SENSOR, and IAT SENSOR.
My car has an automatic transmission.

Your transmission has internal issues with the solenoids or the transmission is trying to go into reverse and forward gears at the same time stalling the engine. Have each of the codes tested to see if it is internal transmission issues or problem with computer.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. 1998 Ford Ranger 2.5L stalling when put into drive.

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: After i changed the crankshaft position sensor, i have a code p0302 which is a misfiring code.

The crankshaft and both camshaft position sensors should be replaced at the same time. Nissan had recalls on these sensors. Also, a simple compression test should be performed to verify no mechanical issues exist. This car is known to have...

Q: My truck started to vibrate, lose power, etc.

Hi. When your Check Engine Light is blinking during acceleration, this usually means that the engine is misfiring in more than one cylinder of the engine. The by the engine misfiring, it causes the computer to adjust how the engine...

Q: Q: Fuse keeps blowing.

Hi, it sounds like you may have a injector that is shorted to ground or an injector cable that is shorted. You can test them with an ohm meter. I would suggest getting a mechanic, such as one from YourMechanic,...

Related articles

How Do Power Car Windows Increase Passenger Safety?
Power windows are responsible for approximately 2,000 emergency room visits every year. When a power window closes, it exerts enough force to bruise or break bones, crush fingers, or restrict an airway. Though...
P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...