My cluch pressure arm I think is brokw in half and I have...

My cluch pressure arm I think is brokw in half and I have no cluxh. It's a mitt max 1990 2.0 Mechanic's Assistant: Besides this, what condition is the car in? Little fender bender in the front routine oil changes other th...

My cluch pressure arm I think is brokw in half and I have no cluxh. It's a mitt max 1990 2.0 Mechanic's Assistant: Besides this, what condition is the car in? Little fender bender in the front routine oil changes other than that nothing major oil leak other than that make a good truck Mechanic's Assistant: What is the make/model of your '90 car? Mitsubishi Mighty Max 1990 2.0 Mechanic's Assistant: Are you fixing your Mighty Max yourself? What have you tried so far? I replaced my starter and replace my brake line but typically if I can do it I do it myself Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? My front end was a little looser than normal right before it happened I don't know if that makes a difference I'm just a bad oil leak

Automotive Expert
Welcome to JustAnswer Mechanical Support! I am AutoExpert20 and I will be Investigating and Supporting your question today. I understand it can be really frustrating when your auto is not working an expected but don't worry as I am here to help! I may need further information, however, if required I will let you know! Sorry to hear your having issues with your vehicle I will try to assist you. You will need to check underneath to see if the clutch arm is operating whilst some one operates the clutch if it is broken you should be able too see the fault also check no fluid leaks if it is a hydraulic system at the clutch slave cylinder also check the clutch fluid make sure it has not dropped. If the clutch arm is broken normally you jave to remove the transmission to change that component.

That's what I was afraid of cuz it is broke off in the main part in my motor comes out 2 bar in that bar goes to have cable because in my motor that bar is broke enoughSee the white thing at the bottom of picture a little white thing right above that it's hooked my motor that's the part of broke that arm right there that is hanging dim

Customer attachment 1/9/2021 5:18:34 PM
Automotive Expert
If the clutch arm is broken you probably will need to remove the transmission to replace it I would check the clutch plate for wear while you have got the transmission removed as it is an easy job with the transmission removed.

Do I need to replace my arm by removing the transmissionShould be that hard to just a little Motors it shouldn't be that hard.
Automotive Expert
Please send some m9ore images a bit clearer as last 1 was a bit blury.

That's the only picture I have right now but my cable that comes to the arm that is broke it is leaking oil that's probably not a good thing either huh my clutch is running fine though
Automotive Expert
That leak looks like it could be the rear main crankshaft oil seal.

Ok it needs some TLC but I'm pretty sure I could probably fix it thank you
Automotive Expert
Your very welcome and good luck.

What others are asking

Vehicle shutting off after a loud squeal.
Based on your description I believe you could be having one of two things happening. One explanation of your squealing noise could be a slipping serpentine belt. This belt drives all the accessories attached to your engine such as your...
Car won't start after security system malfunction.
With your vehicle it is possible that there may be a fault in your security system that is not allowing your truck to start. There may be a fault code stored in the computer of your truck that may help...
Car jerks during quick acceleration
You may have a misfire in the engine or low fuel pressure from a bad pump (, clogged filter (, or both. I recommend having a mechanic test the fuel pressure and volume to see if the fuel pump is...
Brake pads, discs, and sensors replaced
Hello. Your vehicle has sensors that are installed into certain brake pads which alerts the driver when the brake pads are worn down ( to a certain point. These sensors need to be replaced whenever the brakes are done. They...
Car has fuel compression and spark but it won't start.
Hi there. From the description you have provided, it would appear you have replaced everything related to the vehicle's engine running. Obviously, replacing components without a diagnoses is not working. It could be, a faulty ignition switch ( allowing the...
What is causing my warning lights to come on?
Your battery and charging system will need to be tested to see if the alternator is charging correctly. The alternator is most likely the cause of your Charge Light and Battery Light ( coming on. You should replace the alternator...
The truck shakes and there's an imminent smell of gas but no signs of leakage. When accelerating it also backfires multiple times.
Hi there. If there is a smell of fuel in the engine compartment, then the fuel injector o-rings are not sealing and causing the smell of fuel to vapor out. The backfire event is caused by the ignition either being...
Can the parking brake be adjusted ?
Hi there. If your Lexus has rear disk brakes, there are two different ways to adjust your brakes. One is to back up about 10 miles per hour and apply the parking brake. The other way is to remove the...
Reduced engine power.
Check the wiring to the throttle pedal position sensor on the gas pedal and see if there is a loose or broken wire in the pig tail. Fix any wires that are coming apart and wrap up the wiring with...