Have a land rover free lander 2003, bought it last weeken...


Have a land rover free lander 2003, bought it last weekend brought it home no problem, recent seviced, yesterdy when i pulled up outside my house the engine management light came on and i didnt use it again until this morning, i g...

Have a land rover free lander 2003, bought it last weekend brought it home no problem, recent seviced, yesterdy when i pulled up outside my house the engine management light came on and i didnt use it again until this morning, i got in it and when i turned the ignition it made a clunk noise and then wouldnt turn over but made a whinning noise each time i turned the key. a couple of points, when i collected the car last sunday the man said he had done oil and water etc, so i had no reason to check, however for some reason this motring i decided to check and there was oil but no water !!!! my fault for not checking when i collected, second point is that since picking it up i have had trouble with the alarm and immobilizer it takes several attempts to disarm the jeep and several combinatioona of the fob and key then eventually it will dis arm it could be posible the immobilizer isnt fully disarming or battery/alternator/starter issues ? Mechanic's Assistant: Does the battery look like it's leaking? And does it have a strong smell -- like sulfur? No the battery looks new Mechanic's Assistant: What is the model of your '03 land rover? Free lander kalahari 1.8 Mechanic's Assistant: Are you fixing your vehicle yourself? What have you tried so far? I am waiting for the mechanic to come out but i am concerend i have done damage and caused this with having no water to be honest the first time it happened just made a clunk and wouldnt start it stared after another couple of attempts, i activated the alarm via fob, then deactivated and turned it over with the key and it started and drove ok and started a lot after but this morning it wont at all just the whinning noise Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? No i think i have told you everything its my dream car i am devastated i have broken it

Automotive Expert
Hello im here to assist you, it sounds like the starter motor is faulty, the water loss could be head gasket , this model and engine is proned to this.. Please top water up and see if you can see a leak, if not have the head gasket tested...The starter motor needs removing and bendix cleaning and bench testing...Please keep me informed on progress....

Ok I'm guessing head gasket is a big job ? Would I have done any damage because I haven't noticed the water ?It was serviced in last 6 weeks would they have noticed a leak?
Automotive Expert
If its the head gasket you wont see the water because it goes out the exhaust from cylinders. Head gasket test will tell you straight away, if it s the head gasket have the cylinder head skimmed and crack tested this is very common on this engine...

Is this expensive I only just got the jeepWhat if they our a computer thing on the car and test will that tell them head gasket ? Is it best to get the test done and replaced if faulty before it goes would this be less expanse
Automotive Expert
The OBD scanner will not tell you this, you need a correct head gasket tester it reads the co gases in the water system... The gasket job will cost £1000 to £1200 .Sorry , canyou return the vehicle.. Until its tested we will not know....

Still not sure what you need?

Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.

What others are asking

Car shifts roughly and jerks
There is most likely a problem with one of the sensors on your engine. Depending on which sensor fails, and how it is failing, signals may be sent to the computer that can make the transmission shift harder because it...
Car does not accelerate above 2000 RPM
You either have a clogged fuel filter or low fuel pressure. Change the fuel filter and then check the pressure. If the problem continues then you may need to have a diagnosis done on the mass air flow sensor or...
Engine burns oil on a '97 Integra
If it's running rich, it can easily flood the engine out and cause it to burn oil. So I would work on that first. But that said, realize that the only thing you are testing the engine compression is the...
My car is overheating even after replacing waterpump and thermostat
Hi. It sounds like the heater core is clogged and restricting the flow of coolant in the coolant system. There is also the possibility that the new radiator is defective (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-radiator) and is causing the car to overheat. The head...
Service Brake System Light beeps on for a minute then turns off
There is a problem with your brakes or the ABS that is turning this light on. A code reader should tell you what specifically is the problem. Most likely, a wheel speed sensor (https://www.yourmechanic.com/services/wheel-speed-sensor-replacement) is dirty or has failed. This...
Push button not starting car sometimes.
When you are starting the vehicle, make sure your foot is firmly applied on the brake pedal before pushing the button. If you ever notice your brake lights do not come on and the car doesn't start, there may be...
Car shakes violently after a few minutes of driving
This may be a sign of a clogged catalytic converter. As you may already know, the catalytic converter converts toxic exhaust gases into less harmful pollutants that are suitable to be expelled into the atmosphere. When this is clogged, this...
First the service traction control message came up and after it was the service stabilitrak. Two days later the reduced engine power light came on.
Hi there. There is an issue with the traction control system and it may be active with the loss of power happens. Check the brake system for any loose or damaged wheel speed sensors. The traction control system works when...
Car overheats and no heat 2004 Nissan Cube3
Hi there - your symptoms may describe more than one problem. A weak water pump could cause inadequate water circulation that is causing both overheating, and poor heater function. The engine overheat, but not heat until you rev the engine...