Q: Speedometer and odometer not working

asked by on February 16, 2016

My speedometer and odometer are not working. My Check Engine light is also on.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Car jerks heavily at stops
I am sorry to see that your newer BMW is experiencing issues with noise so quickly. Though ideally I would have more information before providing a diagnosis, I will attempt to hopefully steer you in the right direction toward what...
How do I reset the trip odometer?
The trip odometer allows you to track the distance you have driven over a period of time. The trip odometer will track all of the miles that you drive until you reset it, at which point it will start over....
Excessive oil consumption
The manufacturer says that if you are using 1 quart per 1000 miles, then this is considered okay and is normal in their eyes. The problem is you will not have any recourse if this is what you are using....
Van shakes, makes knocking noise - 1993 GMC G2500
Hello. You will need to find out if your engine is misfiring due to an ignition part like plug wires (https://www.yourmechanic.com/services/ignition-cable-spark-plug-wires-replacement), plugs (https://www.yourmechanic.com/services/spark-plugs-replacement), or distributor parts like a cap and rotor (https://www.yourmechanic.com/services/distributor-rotor-and-cap-replacement) or the module. If all the tune-up maintenance...
AUDI A3 1.6L - Engine overheating and temperature needle starts above minimum
Hi, thanks for writing in. It is possible that you could have a faulty water pump (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-water-pump). The water pump is designed to circulate the coolant through the engine. The water pump has an impeller inside of it and it...
Acceleration Issues
If your Nissan has detected an issue with your transmission in any way, it will typically trigger a setting from the Engine Control Module (ECM) called "limp mode". Limp mode limits the transmission to only second gear, which keeps your...
What do I do when the MAF isn't creating enough ground to the ECM module?
Hi there. First, check the harness connection on the sensor for any burned or corroded pins. That will cause a restriction and make the power drop. If the harness is good on the plug end, then disconnect the harness from...
Why is my power steering fluid bubbling up a bright orange fluid? Is that rust?
Hi there. Unfortunately, basic ATF is not the recommended power steering fluid for your 1998 Toyota Camry. The power steering fluid that is recommended for your vehicle is either Dexron II or Dexron III. It's likely that the wrong fluid...
2005 Toyota Camry engine swap
The alteration in weight will require suspension/alignment modifications that will have to be engineered. The carryover of the PCM and all controls must be comprehensive but even if you can get it to work, you might run into issues using...

Related articles

P0195 OBD-II Trouble Code: Engine Oil Temperature (EOT) Sensor Malfunction
P0195 P0195 code definition Engine Oil Temperature (EOT) sensor malfunction What the P0195 code means The intended purpose of this code is to indicate if there is a problem with one of the circuits that monitor the engine oil temperature....
P2086 OBD-II Trouble Code: Exhaust Gas Temperature Sensor Circuit Range/Performance Bank 2 Sensor 2
What What the P2086 code means? P2086 is an OBD-II generic code for the exhaust gas temperature sensor circuit signal is out of range for bank 2 Sensor 2 to the engine control module (ECM). This means the sensor signal...
P2423 OBD-II Trouble Code: HC Adsorption Catalyst Efficiency Below Threshold Bank 1
P2423 P2423 Code Definition A P2423 code is a generic powertrain code related to emissions systems problems. In this case, the hydrocarbon adsorption and catalyst efficiency is below the allowed threshold in engine bank 1 (typically the number 1 cylinder)....