Q: My 2010 Ford Explorer power trans light came on

When using a seat belt to secure a child restraint system, follow these steps: 1. Place the restraint firmly in the seat. 2. Grab the shoulder belt and lap belt together, directly behind the belt tongue. 3. Route both ports...

Hello, thanks for your question. You could watch the clutch fluid as it mentions in the test, but this really doesn't tell you much. Most of the time this is caused by a bad clutch master cylinder (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-clutch-master-cylinder). If the...

Hello. Though there are a lot of possible causes of this, the most common is the crankshaft position sensor. These fail all of the time on this engine. Before I change it I would usually scan the computer for codes....

Hi there. The code 12 is for your distributor has no reference. When the engine gets hot, the secondary circuit on the ignition coil gets hot and will not work. I recommend replacing the ignition control module and then recheck....

Hi there. To properly repair your vehicle you need to use the correct ignition coil. If you do not use the right coil then it either will not work or it can damage the circuit and the computer. The resistance...

Hi There, These two tires are not much different in that the size difference will be hardly noticeable. The dimensions to each are as follows: 175/65R/14 Diameter 23" Width 6.9" Sidewall 4.5" Circumference 72.1" 165/65R/14 Diameter 22.4" Width 6.5" Sidewall...

Hi Marie: With regard to the code P1372 that was downloaded, there are many potential malfunctions that will cause P1372 to set in addition to the crankshaft position sensor itself being faulty. And, if the sensor itself is suspected as...

The fuse is only one component in the power supply to this unit. There is at least one relay, a switch, sensors, wiring and probably a control module, not to mention the motor and track. What you can initially do...

If the illumination of the check engine light is truly "related" to the fuel quantity, the issue might be a fault in the EVAP system. One way to find out for sure is to download the trouble code(s) that are...