Q: Manual transmission gears won't shit ford focus 2006

Hi there. The A/C compressors are known for failing on these vehicles quite often. There are countless reasons your A/C might not be working, ranging from low refrigerant to electrical issues. I suggest you have a certified mechanic, such as...

Hello. Most of the time, this is the first indication that the timing belt is failing (https://www.yourmechanic.com/services/timing-belt-replacement). The timing belt needs to be checked to see if it is going bad. If the belt is fine, then you may have...

Hello there, thank you for asking about your 1986 BMW 635CSi. It sounds like you've checked all of the low hanging fruit. The previous owner may be right - some vehicles (only German ones come to mind) can develop a...

It does appear as though you will need to remove the intake manifold. My information system doesn't give specific instruction for the oil cooler hoses, but it does give information about the oil cooler. This sort of situation isn't out...

Looking at the Isuzu repair documentation, I see no service bulletins that would indicate a programming update for an extended crank or no-start condition although there are software enhancements all of the time and not necessarily a bulletin-related to the...

There are quite a few oil seals and gaskets on your engine and so the exact source(s) of the leak would have to be pinpointed during an oil leak diagnostic (https://www.yourmechanic.com/services/oil-fluid-leak-inspection). If you do have oil leaks, as many leaks...

Hi There, What you are describing sounds like a dirty or faulty idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement). The idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) monitors the air intake as it is mixed with fuel prior to being injected into the engine...

Failed wheel bearings will cause a lot of noise. You also might be able to detect "roughness" if you turn the wheel/tire by hand if the car is on a lift. However, wheel bearing failure will not cause difficulties in...

There is a relearn/calibration procedure that is typically performed whenever the throttle position sensor is replaced. If that procedure was not performed, it might be relevant in your case. The code (P0121) that you are referring to implicates not just...