Q: Im putting in a2005 ford 4.2 in my 98 ford f150 do you see any problem

asked by on

Im putting a 2005 ford 4.2 in my 98 f150 do you see any problem

My car has 100000 miles.
My car has a manual transmission.

Hello. If you are using the base engine then you should be just fine. The intake and exhaust as well as the sensors will work different so all of that will need to be switched over.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Im putting in a2005 ford 4.2 in my 98 ford f150 do you see any problem

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Heavy oil leak when car is on

The first thing to check is the oil filter. Was the oil changed recently? Remove the filter and check the gasket. Did it push out of the groove? Are there two gaskets? Some other sources of pressurized leaks are a...

Q: Q: Not starting

The most common cause of an no start with no spark is going to be the crankshaft sensor causing the no start. The vehicle should be scanned to see if there is an input from the crankshaft sensor to the...

Q: ABS pump bad soft pedal - 2008 Ford Fusion

Hello - Yes, a replacement ABS pump must have the same part number as the pump it is replacing. These units are specific to your vehicle (make/model/production group), and have to match for the software that drives them to operate...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...