Q: How to install electric body control model

asked by on September 05, 2016

Stalling a electronic control model

My car has 130000 miles.
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Car makes a clicking sound when turning
Hello! One general giveaway of a bad CV axle is a clicking sound when turning. CV axles are vital to the stability of the vehicle and they transfer the power to the wheels to make them turn. Noisy CV axles...
Car jumps when speeding up or slowing down
Sounds like you might be having an issue with your hub bearing. The hub bearing is a sealed bearing that the tire rotates on. These bearings wear out over time and usually make growling/scraping type noises. The noises are sometimes...
Changing the front struts as a complete assembly
When I looked up the parts, the struts should be the same on both sides. When installing the struts, you need to make sure the top mount is in the same position as the removed one before you try and...
Gasoline pours out of the almost empty gas tank
Hi there. This is typically caused by one of two things. The most common being a bad fuel tank vent valve. This valve should open while fueling allowing the fuel vapor to be released to keep the fuel from backing...
Okay so this is all very stupid I know. So I was doing donuts (yes doing donuts in my fwd suv)
Hello, thanks for writing in about your Buick Rendezvous. From what you've described, you most likely damaged the transmission. You will need to take the vehicle to a transmission mechanic to fix this particular issue. If you'd like a second...
Loss of power and jerking when accelerating
Hello and thank you for contacting YourMechanic. This sounds like the turbo shift broke and the turbo quit working. To test the turbo, put the vehicle in an open area and set the parking brake. Step on the service brake...
There's no pressure in my brake pedal
If you had multiple components of the brake system replaced and have already repaired leaking brake lines, then the next thing you need to do is verify that the brake master cylinder is full of fluid and stays full. Once...
Why would There be no power when I press on the gas?
If the engine Revs up, but the car does not accelerate, then your transmission must be slipping. You can check the fluid level in the transmission and add some if it is low, but even if this solves your problem,...
My 06 malibu had slow acceleration only in first gear i had a mechanic change the shift solenoids now in reversa and neutral it on
The transmission may have additional problems and should be scanned for additional codes first. If there are additional service codes then you will need to have those codes diagnosed. The vehicle should not move in neutral unless it is pushed....

Related articles

How to Tell If Your Car Switches Are Dying
Since Since every part of your car is controlled or operated by a switch in some fashion, it is to be expected that the switch will eventually fail. Some of the most commonly used switches in your car are: Power...
How Long Does an Electronic Control Relay Last?
So So much of your vehicle relies on electronic components nowadays. They all work in conjunction with one another, so that means when one fails a domino effect takes place, and they all start to fall. The electronic control relay...
How Long Does an Electronic Ignition Pickup Last?
Your Your vehicle depends on electricity in order to run, and this electricity can be traced back to the spark plugs which create a spark to ignite the fuel. It’s a whole process, where each step depends on the other...