Q: How much to change timing belt and water pump plus valve cover gasket clean replace also other belts spark plugs oil change

The fuel pressure on this vehicle is supplied by the fuel pump in the tank. The fuel pressure would need to be checked, as well as the fuel pump for proper power; you may need to replace the fuel pump...

The "Check Engine Light" indicates a fault being stored in the engine computer. A triangle shaped light with a circle around it indicates a fault in the electronic stability control. To diagnose these issues the faults will need to be...

It is possible, but the price of R12 is very high. It will be expensive because of the price of R12. There is an initial extra cost to convert your system to R134a, but once it's done, it will be...

Hey there, thanks for writing in about your 1990 Mercedes-Benz 300D. Typically there are a couple of different options in the interior light switches. There is usually an option to turn them on manually, or to have them come on...

There are a number of driver-set functions which may cause the "3-beep" symptom: "top of the hour" clock warning (so you can catch the news), speed warning, icing conditions warning, etc. These are all set on the On-Board Computer. Check...

For the first issue, the gas cap will need to be replaced sometimes. I had a 2009 Dodge Charger that this happened to also. It's not something you can control. As for the second issue, it seems like it is...

Hi there. For your 2010 BMW, the [P0025 is the OBD-II error code] that (https://www.yourmechanic.com/article/p0025-obd-ii-trouble-code-camshaft-position-b-timing-over-retarded-bank-2-by-jay-safford) indicates the Engine Control Module (ECM) determines that the exhaust variable camshaft timing for bank 2 is more retarded than what the ECM desires. This...

Hello, This suggests that one of two things are happening. Either the motor is in fact low on oil or the oil pressure sending unit (https://www.yourmechanic.com/services/oil-pressure-sensor-replacement) is not working properly and may be producing a faulty reading. I would recommend...

Hi there. In most cases, when you attempt to jump start the vehicle and it doesn't work, it's due to a damaged starter relay, the starter motor or the ignition relay itself. Before you complete any repairs however, it's a...