Q: How much thread should be left out on a tire rod link for a Buick raodmaster

Hello. Unfortunately it sounds like you may have replaced some parts that may not have been needed. The most common cause of this noise on your vehicle is the front struts and the front stabilizer link pins. I start by...

If the Check Engine Light is on then you would need to have the computer checked to see if the code received pertains to the problems you are having. Not getting the valves adjusted may start to cause misfire codes....

Hello. The power steering in your 2007 Chevrolet Express is run off of vacuum from the engine. If there is a vacuum leak in the engine’s system, it will cause the problem that you are experiencing. The brake booster (https://www.yourmechanic.com/services/brake-booster-vacuum-pump-replacement)...

The blue smoke coming out of the exhaust is an indication that the motor is burning excessive oil. The Mazda 3 engines are known for this. When the valve seals become worn this can cause oil to seep into the...

Hi there: The crankshaft position sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-crankshaft-position-sensor) on a six-cylinder Jeep Wrangler is going to be located behind the front motor plate, next to the timing chain/belt. Sometimes, however, the P0335 OBD-II error code (https://www.yourmechanic.com/article/p0335-obd-ii-trouble-code-crankshaft-position-sensor-a-circuit-malfunction-by-spencer-clayton) is not indicating the crank...

Hi There, This maybe related to potentially a transmission problem resulting from low transmission fluid. As you know, automatic transmissions use pressurized hydraulic fluid to change gears. Every time a gear change is required, the car's computer activates a transmission...

Hi there. You might want to read this article for starters (https://www.yourmechanic.com/article/how-to-disable-a-car-alarm). Since this is an aftermarket alarm system, you'll need to find the fuse that the system is installed and remove that for starters. Unfortunately, this is not a...

If you have already found the reason for the fuel flooding the cylinder then you will need to remove spark plugs and disable ignition and turn over motor to get out excess fuel. Then you will need to replace the...

It is possible that you have an internal transmission issue. It is also possible that the clutch itself could be worn out causing this issue. I would recommend having a qualified professional inspect your transmission to determine the exact cause...