Skip the auto shop - Our mechanics make house calls

Q: How do I adjust the courtesy wipe?

asked by on

How do I adjust the courtesy wipe?

A: The courtesy wipe feature can help keep you...

The courtesy wipe feature can help keep your windshield clean after using the windshield washers. A few seconds after the washers and wipers have stopped operating, the courtesy wipe will make the wipers wipe one last time, to wipe away any remaining washer fluid that may have dripped down. This feature can be turn on or turn off very easily. 1. Press the Up/Down buttons on the steering wheel until Settings is displayed on the instrument panel, then press the OK button. 2. Press the Up/Down buttons until Convenience is displayed, then press the OK button. 3. Press the Up/Down buttons until Wipers is displayed, then press the OK button. 4. Press the Up/Down buttons until Courtesy Wipe is displayed, then press the OK button. 5. Select On or Off.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: I replaced the battery, alternator, did a tune up and changed the fuel filter. The truck still has trouble starting

A hard start or stall after starting is most likely caused by a fuel pump that is not holding pressure up to the fuel injectors after you shut off the engine. The fuel pressure should be tested to verify the...

Q: How do I use the electronically shifted transfer case?

If your vehicle has an electronically shifted transfer case, then you handle all of the shifts between two and four-wheel drive from the center console. The electronically shifted transfer case is as a knob on your center console with three...

Q: Car won't turn over or start but will push start.

Hi there. It could be your distributor or another ignition system component such as a crankshaft or cam position sensor, faulty spark plugs or a bad coil. It's also possible that your ignition relay is damaged, if you're able to...

Related articles

What Causes Hoses to Leak?
While the largest part of your engine is mechanical, hydraulics plays a significant role. You’ll find fluids at work in a number of different areas. Your car's fluids include: Engine oil Transmission...
P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the P0052 code means This code is seen when the Engine Control Module (ECM) tries to control the...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...