Q: Check engine light is on.. Its not running any differently and it starts normally..

asked by on August 19, 2016

Check engine light is on
My car has an automatic transmission.

Check Engine Light is on Inspection $79.99 - $89.99 Get a Quote

You need to have the engine computer scanned to see what trouble code is stored. Not all codes will cause the engine to run bad or cause a noticeable problem. For instance, a trouble code could be triggered by a loose gas cap.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

How to find and replace my egr valve on a 2008 Dodge Avenger r/t 3.5 fwd

Hi there. You might want to watch this video on replacing the EGR valve on a Dodge Avenger to determine where it is located and whether or not you feel comfortable completing this service. It is rather easy when you...

my car wouldn't start and found out my battery was 5 years old so got a new battery. now having the same issue a couple days later

Hi Haley. Thanks for contacting us tonight. When a battery dies quickly, it is often caused by a malfunction of the battery charging system. The alternator is responsible for this task, but there are other parts like the battery temperature...

Water under passenger seat and mildew problem

If the A/C evaporator drain is clogged or partly clogged, then the water condensation from the normal A/C operation cannot drain out of the evaporator case and has to go somewhere. The place it usually goes is out of is...

Leaking power steering oil

You do have a leaking power steering system and if you cannot locate the leak then it may be collecting in the inner tie rod boot and leaking from the rack and pinion side seal. If you're unable to pinpoint...

Light stays on in car.

There is a good chance that the gate sensor is malfunctioning. This is not an uncommon problem. I would enlist the help of a qualified technician to pinpoint the problem and confirm that the sensor is malfunctioning.

My daughter's check engine light came on with a code of P1004 on a 09 Dodge Charger. We changed the short runner valve, the light

The short runner valve actuator that you replaced is just the electric motor that moves the short runner valve to its correct position. However, the problem is likely that the valve itself within the intake is sticking. Using an appropriate...

obd trouble code p0014 , hard up shifting

The code P0014 is for the cam sensor but since you already replaced it, then you will have to have the camshaft end play checked per a technical service bulletin (TSB) to see if it is in excess of specifications....

Accelerater is not working.

The most common causes of Diagnostic Trouble Code P2118 are failure of the throttle actuator control motor, a failed pedal position sensor, a faulty throttle position sensor, an open or short in the actuator circuit, or a poor electrical connection...

Speedometer and gears failed; car towed - 2009 Kia Borrego

It seems like the problem is one the shop may have not experienced just yet or they may have found a big problem and are trying to work with Kia directly for warranty or recall information. Take the vehicle back...

Related articles

P1103 OBD-II Trouble Code: Mass Airflow Sensor in Range But Higher Than Expected
P1103 means there is an issue with the mass airflow sensor, likely due to faulty or loose wiring and connectors in the sensor, or an air leak.
P2190 OBD-II Trouble Code: System Too Rich at Idle Bank 2
P2190 P2190 code definition System Too Rich at Idle Bank 2 What the P2190 code means This code indicates there is too much fuel in relation to air (air/fuel ratio) in bank 1 at idle only. Bank 1 is...
P2631 OBD-II Trouble Code: O2 Sensor Pumping Current Trim Circuit High Bank 2 Sensor 1
What What the P2631 code means? P2631 is an OBD-II generic code for the engine control module (ECM) detecting an open or short circuit in the Air Fuel Radio (A/F) or O2 sensor, causing a high voltage at the signal...