Q: Can i put a 2000 chevy blazer motor into a 1996 honda civic

The brake light is an indicator that is used for many different reasons. The light can be for low fluid levels in the brake master cylinder, ABS backup failure light, parking brake light switch (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-parking-brake-warning-switch), and the dash test circuit....

You may have to get the system reprogrammed. I have seen cases where the battery goes below a certain voltage, or a voltage surge happens, causing the system to lose its programming. You will need to have the dealer reprogram...

Hi there. If this occurred right after an accident, then it may have damaged the wheel speed sensor (https://www.yourmechanic.com/services/wheel-speed-sensor-replacement). If you have the spare tire on the vehicle then this can occur also. Usually when this problem starts happening it...

When you have low fuel pressure but recently replaced the fuel pump and relay, the issue is typically vacuum-related or caused by a clogged or worn out fuel injector (https://www.yourmechanic.com/services/fuel-injector-replacement). The vacuum issue may be related the the EGR valve...

This may be a sign of a dirty or failing mass air flow sensor. The mass air flow sensor is a unit in the intake system that monitors air intake as it is mixed with fuel prior to being injected...

When cooling systems are re-filled (after thermostat replacement for example) air can get trapped and that trapped air can prevent normal circulation of coolant. That, and low coolant level, would be the first things to check. If no problem is...

Hi there. It is highly probable that you have a faulty main relay or an exposed electrical connection or bad ground to the fuse panel that is causing this issue. However, it could also be problem with the ECU itself;...

Hi Ronnie. Thanks for contacting us today. There are multiple components that could be causing these codes. The P1777 code is a BMW specific trouble code that indicates a possible problem with the transmission step motor. This component changes the...

If the problem is simply no starter motor operation the fault is typically quite limited. With a fully charged battery that passes a load test, or a new fully charged battery as required, and the immobilizer (security) system off -...