Q: My truck runs for a few seconds then dies

asked by on

I replaced the fuel pump,relay, and pressure regulator in my 2001 dodge ram 1500. It starts but runs for a few seconds then dies. It has only 10lbs of pressure when it runs and 0 with just the key on. When it runs I can give it gas but it sputters team dies. What could be the problem?

My car has 396000 miles.
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. My truck runs for a few seconds then dies

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Bank 1 running to rich and injector 1 contribution fault Intermittent.

Hi and thanks for contacting YourMechanic. What you are experiencing is a misfire detected in cylinder 1 and a random misfire in cylinder 3. This could be caused by either the fuel injectors not firing, the spark plugs fouling out,...

Q: Does Blue Devil work?

Using any kind of head gasket sealer will not ever replace a new head gasket replacement. These sealers just pack themselves into the leaking gasket and then harden. They may clog other passages at the same time in the heater...

Q: cylinder number 4 has a misfire.

Billing question sent to CS for the cost to diagnose and repair a possible burned valve on a 2008 Jeep Commander with a V6-3.7L engine.

Related articles

What Causes Hoses to Leak?
While the largest part of your engine is mechanical, hydraulics plays a significant role. You’ll find fluids at work in a number of different areas. Your car's fluids include: Engine oil Transmission...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.