Q: cylinder number 4 has a misfire.

asked by on January 26, 2017

My jeep commander is showing a #4 cylinder misfire. My Mechanic thinks that it has something to do with the valves (sounds like one is hanging and it is rattling) what is the typical cost of taking aprt the valve cover assembly and getting in there?

My car has 113000 miles.
My car has an automatic transmission.

Billing question sent to CS for the cost to diagnose and repair a possible burned valve on a 2008 Jeep Commander with a V6-3.7L engine.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Car idling rough after replacing alternator

After replacing the alternator, your vehicle's ECM will need to go through a "relearning" process whereby it will take a day or two for it to relearn the computer's parameters and adjust. If by replacing the alternator, the battery was...

I have a 2011 hyundai genesis coupe 2.0 84540miles. When the ac is turned on the car shakes drastically.

The a/c system loads the engine when the a/c is turned on. To maintain engine speed and power, there is an "idle-up" control circuit. That control may be malfunctioning in your case. Another possibility is a problem elsewhere in engine...

Vehicle stall while driving. Crankshaft Position Sensor and Coolant Temperature sensor replaced.

Was the output of the crankshaft position sensor viewed on a scope? If not, the sensor might have been perfectly good. If you are working off of codes please note that the mere presence of a code is not enough...

Too lean in bank 1 and bank 2

Hi and thanks for contacting YourMechanic. When the engine becomes too lean, then combustion chamber becomes very hot causing the head gasket to burn, valves begin to burn, and the rings being to seize up. Check the camshaft sensor and...

When replacing ball joints can you just replace the ball joints or do you have to replace the whole control arm?

The ball joint on this vehicle can be replaced separately from the lower control arm. However, on this vehicle it is also a known problem where the ball joint becomes loose inside the mounting in the lower control arm and...

My speedometer is going back and fourth and drops to zero while driving but, my rpm gauge is fine.

Hello. The crankshaft position sensor will not cause a fluctuation in the speedometer gauge. It can affect the rpm gauge, but not the speedometer. If the speedometer is acting like this then most of the time this is caused by...

Crunching, grinding, popping under front end

It sounds like the brake pads or wheel bearing may have failed. If the brake pad surface is worn, it will grind against the rotor surface, especially during braking. The bearings could also be to blame. Over time the...

Related articles

Symptoms of a Bad or Failing High Pressure Safety Valve
Common signs include the Oil Pressure Light illuminating, increased engine noise, and oil pressure dropping.
Symptoms of a Bad or Failing Positive Crankcase Ventilation (PCV) Valve
Common signs of a faulty PCV valve include excessive oil consumption, oil leaking, a blocked breather filter, and reduction in overall performance.
Symptoms of a Bad or Failing Ignition Coil
Common signs include the Check Engine Light coming on, engine misfiring, rough idle, a reduction in power, and the car not starting.