Popular questions

Question
Steering wheel knocking sound when stationery
Hi there. If the wheel is rotating when the steering is turned and you hear a knocking sound, then this is the sound of a constant velocity (CV) shaft bearing failing. Remove the front wheels and check around the CV...
Question
Does jacking up a car in one corner damage the chassis or sway bars.
If you use ONLY the jack, and support points, specified in the Factory Service Manual (FSM), no damage will occur. These contact points might also be specified in your owner's manual and shown there in illustrations. Please note that if...
Question
Vibrates with acceleration just spent 900 on shocks struts suspension repair & 300 brand new tires
Hi Cat. Thanks for contacting us today. I'm sorry to read about these constant problems you're experiencing with the Toyota Corolla. In most cases, a vibration like you're describing is caused by a steering or suspension component failure, or a...
Question
EPS light
Hello. The EPS light comes on when the computer detects an issue with the vehicle's electronic power steering system. If the computer detects an issue with the system it will set off the warning light to notify the driver of...
Question
My gear stick moves but my car won't move. It was extremely low on oil. Added some 2 days later. Do you think it locked?
Hi there. If you can turn on the engine, then the engine did not lock. This could be a cause of the transmission having an issue. Check the transmission shifter cable to see if it has broken or came off...
Question
I can't go into 4th or 5th gear and clutch does not engage after a recent clutch job, clutch release while in gear does nothing.
I would rule out the axle not being pushed all the way in. That would effect all speeds and gears. That you can engage gears other than 4th and 5th leads me to 2 m possibilities: 1. Shift linkage mis-adjusted....
Question
I put a new ignition switch in my 2004 Chrysler Pacifica but it still wont start, how do I program the ignition switch?
Hello. When the ignition switch is replaced in this vehicle it does not need any programming. The switch is a set of internal connections that simply complete circuits. If the vehicle did not start before then the switch is probably...
Question
Green light doesn't come on when shifter is placed in drive
Each transmission range display has a separate bulb that lights up. The instrument cluster can be removed and the bulbs can be replaced individually. My recommendation would be to enlist the help of a mechanic, such as one from YourMechanic,...
Question
Why is my car making a howling noise and blowing smoke when I accelerate? 2009 Mazda CX-7
Hello - there may be multiple problems contributing to the smoke and noise symptoms you are experiencing. The exhaust smoke you notice could be worn or damaged turbocharger seals, or worn piston rings, allowing oil to reach the hot exhaust....
Question
Is it safe for me to drive around with no muffler, while always having the windows down?
It is never safe to drive with the muffler removed and the exhaust not exiting the vehicle out the back. You should not wait too long before getting it repaired. Remember that carbon monoxide is an odorless and colorless gas....
Question
I'm looking to buy replacement motor mounts. How many of the front and rear do I need? 2004 Nissan Sentra
Hello - there are a total of 4 motor/transmission mounts. Given the transverse mounting of the engine/transmission, there are ambiguities in "front", "rear" and so on. As a consequence, parts manufacturers are offering them as a set. Replacement is best...
Question
2014 hyundai elantra se Electric power steering light turned on. How much will it cost to get it fixed?
Hi...I will try to address your concerns and, as well, obviously you can request an electric power steering diagnostic which will get you a really quick and precise answer as to cost because the mechanic will be able to diagnose...
Question
My heater is blowing air through the driver side air vents but is blowing cold air through the passenger side and rear console ven
Hi there: Climate controlled vehicles have multiple electrical relays that open and close vents to maintain the desired temperature. In some instances, these relays can wear out overtime. However, it's also common for debris to clog up vents (especially side...
Question
Can't find crank shaft sensor 2011 dodge caravan crew 3.6 flex fuel
You sound like you are describing two possible problems. Sometimes the engine will not turn over and other times it turns but will not start up and run. If you have to sometimes put it in neutral to get it...
Question
Rod Knock
Hello. This engine does have a series of common issues that can cause a knock. I have seen quite a few of them with rod knocks, but most of the time the issue is the timing chain. The warranty company...
Question
"TRAC OFF" light came on after diagnostic test for check engine light
Hello. In most cases the vehicle's traction control system is on a completely separate circuit then that of the engine knock sensor. Therefore most knock sensor faults or issues should have little to no effect on the operation of the...
Question
Engine runs, but car doesn't accelerate?
Knowing the results of the computer diagnosis as well as the part that was replaced can be helpful in assisting you with your Pontiac G3. It is possible the part that was replaced is defective and may need to be...
Question
Brake lights not working in a 2002 Chevrolet Trailblazer
Looking at the wiring diagram for your vehicle, I see that all the brake lights share a common ground. They also all utilize the brake lamp switch, so both of these items can be ruled out. The only thing the...
Question
Alternator is overheating...had it tested and was told everything looked good. What would cause this problem?
Hello, thank you for writing in. The charging system is rather simple including the alternator, battery, and the cables. If you have tested the alternator off of the vehicle, there may be another component in the system that is causing...
Question
Toyota Prius 2012 hybrid system light with master warning light, slip indicator, brake system warning and malfunction
The warning lights signify that trouble codes have set and been stored in the vehicle computer(s). Of course, the codes likely reflect the existence of an underlying fault, the severity of which will be unknown until the codes are read...
Question
Vibration/Wobble When Accelerating From Low Speeds
When you disconnected the battery all of the computers for the engine and transmission reset back to the factory settings. When you drove for about 20 minutes, the computers relearned there drive conditions and the way you drive. The vibration...
Question
My electronic throttle control light is flashing and when I press on the gas pedal it doesn't go pass 20-30 mph and stalling
Hello. Thank you for writing in. The two sensors work together to track the location of the pedal as its being depressed. One is located on the pedal while one is located on the firewall. It is best to replace...