Popular questions

If you are having high idle conditions, then you may be having a couple different problems. The first is the idle air control valve may be stuck open allowing too much air past the throttle body. The valve can be...

When you enter your car, you cannot adjust the sunroof without first turning the vehicle on. However, after turning the vehicle off, you can continue to operate the power sunroof. If you have the electronic vehicle information center (EVIC), then...

Hello. Though there are a lot of common issues that can cause this, the most common is a voltage issue. Low voltage will cause each of these symptoms and codes you are getting. I usually start by testing the ignition...

Since you did all this work then you should be able to check the fuel pressure and engine for spark getting to the spark plugs. If you have spark and fuel pressure, then you will need to check the fuel...

The excessive heat may suggest that you may have a caliper sticking or otherwise not releasing from the rotor when letting off the of the brake pedal. When this happens, as you know this creates an intense amount of heat...

Hi there. If you have a radiator in your vehicle, look around the radiator to find a part number so the parts store can cross reference the radiator. If there is no part number, then remove the radiator and take...

The most common cause of this problem is the blower motor control processor mounted in the A/C evaporator case. I'd start by checking that first I were you. I you need some assistance however, feel free to contact a professional...

Hi there. When it comes to buying a vehicle, all vehicles come with a maintenance log. The maintenance needs to be kept up with the vehicle to ensure a safe ride. The Volkswagen Jetta models are dependable and are reliable....

The occurrence of code P0900 is probably not related to Service Campaign 15B22. That service campaign was initiated by Ford because TCM's were failing to set codes (illuminate the check engine light) when faults occur. Your situation is the exact...

It depends on what you are doing. If you only need to replace the upper then replace just the upper. If you need to do the lower then you will need to drain the coolant. On these engines, they leak...

Hello - yes, replacing the air filter could cause the P0113 - intake air temp sensor high circuit condition. The intake air sensor is located in the plastic intake housing that leads to and contains the air filter, so it...

It sounds like the power steering has a low fluid level condition. Check the power steering fluid. If it is low, you have a leak. If the pump doesn't have enough fluid it will make a strong whining noise that...

Although faulty fuel injectors could cause the issue you are describing, the symptoms associated with the diagnostic trouble code you found, namely P0344 are consistent with the symptoms that you are reporting. Consequently, you are better off resolving the fault(s)...

Hi there. Put the key into the ignition and turn it on. Then press the lock button on the key fob and turn off the ignition. Then turn on the ignition and press the unlock button on the key fob...

Hi Brandon. In an older vehicle like your 2000 Ford Expedition, inner transmission seals and gaskets are fairly worn in general. Driving in second gear in an automatic transmission up to speeds of 45 could have possibly damaged inner components...

Hi Courtney. Thanks for contacting us today. I wouldn't recommend removing the condenser until you have the money to replace it. Everything is designed to fit correctly together. When you remove one component, other items will not work or fit...

The radiator fan is used to draw air into the radiator at a faster rate than it would come through naturally. On many vehicles, transmission fluid is routed to the radiator via transmission cooler lines. There is a separate channel...

The power steering pump may whine if the fluid level has become too low from a leak or you may hear a squealing noise if the belt has become too slack. While the belt is off would be a good...

A possibility is the neutral start safety switch is defective. Car designers place that switch in the starting circuit to prevent the car from being started while the car is in gear. Starts in Park or Neutral are the only...

The steering torque sensor is Ford part number CL8Z-3F818-A and it was used from model year 2008 to 2012. The best strategy is to buy a brand new sensor from Ford and install it in your existing column. Ford's recommendation...

Hi Tevin. Thanks for contacting us tonight. If you can engage the starter (meaning it cranks over) but will not start, then it's either a fuel or ignition system failure. Some of the common components that can cause this include...

I believe the humming sound you are hearing could be related to a faulty wheel bearing. When wheel bearings dry out they will begin to make humming or growling noises when the vehicle is accelerating. I would recommend having your...

Hello. The symptoms you describe can be caused by a wide variety of issues. If you have already replaced the ball joints and tie rod ends then I would move on to looking at the vehicle's control arms. If the...