It sounds like you may have an issue with the ABS control module or the wheel sensors on your vehicle. The ABS control module controls the activation of the ABS system based upon inputs from the ABS wheel sensors. When...
Hello, You should check the integrity of the ground wire. If the rubber coating is melted it must be replaced. You should be sure that the alternator they gave you doesn't have a voltage regulator built in or attached to...
This may be related to a dirty or failing idle air control valve. The idle air control valve reads the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at...
Hi there. There is a possible pin hole leak on the fuel system that is drawing in air into the fuel system. This will make the engine stumble as it is trying to start, but when the fuel is moving...
Hello. If your radiator and water pump were recently installed, then those are likely not the components at fault, but it is still possible. If engine performance was greatly affected, it may be possible that there may be a blown...
Usually a vehicle that won't rev in the manner you are describing is due to a plugged exhaust system. The most common culprit here is a catalytic converter that has come apart on the inside. If this is the case,...
The traction control system monitors the steering stability of the vehicle and engages when loss of traction has been detected. This is done by the use of electronic sensors that communicate with the Power Train Control Module (PCM) regarding steering...
In the majority of vehicles, engine idle speed is controlled by an idle control valve (ICV). The ICV valve can fail or a faulty or blown fuse in other electronically controlled systems can cause the IAC motor to malfunction, leading...
P0300 codes are misfire codes. The last digit indicates the cylinder where the misfire has been detected. So your work on the 2nd cylinder ignition is on the right track. But when you have a car that misses at idle...
Hello. The old style of retrieving codes was indeed done by turning the key on and off again. However vehiles manufactured after 1996 are equipped with OBD-II diagnostic systems. This means the driver or technician can acess and even control...
Hi Courtney. Thanks for writing in tonight about your Scion. Although a battery might be charged, it is possible that it has worn out and does not have enough cranking amps to activate the starter and power ignition system components...
The EPS light - Electric Power Steering - can come on for a number of reasons. It can be as simple as making sure the tilt wheel mechanism is fully locked in place, or it can be a number of...
The first thing to check is the Check Engine Light to see why it is on. The smell of rotten eggs is an indication that the catalyst is bad and the rattle may be that the catalyst is broken up...
The vehicle is not only able to heat the front seats, but it can also move warm air out from the surface of the seat. Ventilated seats are great, warm or cold, as they can prevent excess sweating that is...
Generally, the check engine light comes on when something fairly serious is going on with the vehicle. This can happen for many different reasons such as a faulty mass air flow sensor, a faulty O2 sensor, a bad catalytic converter,...
The most common causes of overheating include low coolant level (including that due to leaks), a faulty thermostat, a plugged radiator, a faulty radiator pressure cap, collapsed hoses, non functioning cooling fans, and a faulty water pump or drive belt....
First thing to check would be the condition of the tires. Make sure air pressures are correct for the vehicle. The recommend tire pressure for the vehicle should be found on the sticker typically located in the driver's door opening....
Hey there. It may help to find the fuse for the instrument cluster, remove it for 10 minutes or so, then re-insert the fuse. Chevrolet appears to have had a "customer goodwill" repair available for this if your vehicle had...
The labor to replace the valve cover gaskets should only be 3.0 hours. The list dealer list price for gaskets are only $50. It sounds like you were charged double of what you should of been charged. You most likely...
Hello. No power to the fuel injectors can be caused by a few things. If the relays, fuses, and computer all check out then I would move on to looking at the engine management and fuel system. It may be...
Hello - I believe you have a failure in the reverse input clutch in the transmission. This could be caused by several components in this clutch, all of which will require removal and disassembly of the transmission to repair. To...
While starting your engine is as simple as turning the key and then releasing it once the engine is running, there are some things you should know. The following precautions will help prevent damage to your engine, as well as...
The main thing that stands out is to make sure the transmission shifts very smooth going up and down through the gears. The transmission is very common to have a sticking servo that changes the gears will bind in the...
Hi there. The fluid that is inside the fan clutch has leaked out and is no longer keeping the clutch is a slipping mode until it gets hot. I recommend replacing the fan clutch assembly. If you need further assistance...
HI there. Yes, when the key is turned on any heated oxygen sensor will start to heat up. Most will not continue unless the engine is started. This depends on the vehicle application.
