Popular questions

You probably should have changed the struts in pair at least because now you have an original strut on one side and a replacement strut on the other. The two might be slightly different in construction even if they seem...

Hi there. White smoke coming out of the exhaust is an indication that the cylinder head gasket is burned or the cylinder head is cracked. When coolant is in the combustion chamber, then engine will shake, the oil will burn...

Hi there. It sounds like you have a pretty good idea of what the brakes need. If the rear brakes need to be replaced then that should be done prior to replacing anything else as you do not want to...

Your check engine light being on is an indication the computer has seen a problem in its systems and set a code. the code will need to be retrieved with a scanner and then a pinpoint test done to find...

Any one, or more, out of a list of thousands of OBD-II Diagnostic Trouble Codes could have caused your vehicle's Check Engine Light to illuminate. Even though in your case the check engine light has come on immediately after specific...

The cooling system that is leaking and over 13 years old could be most any component in the system. The cooling system will need to be pressure tested to locate the leaks in the system. The radiators and expansion tanks...

The warnings refer to your vehicle's "Supplemental Restraint System" (SRS) which is the vehicle airbag system. The airbag control computer stores trouble codes in the event of a malfunction so what you can do is request an airbag warning light...

The two modules should have a part number clearly indicated on the top, if they are the same, then the modules are interchangeable. If there is a suffix A or B or something like that at the end, there may...

Surface coatings (paint, powder coatings, etc.) on brake calipers are not required or recommended. Such coatings have no effect on caliper service life and no effect, positive or negative, on any aspect of vehicle operation. The paint therefore services a...

It is very possible that the quality control of those particular parts may not be what it used to be. It just depends on how many times you've had to replace it. Sometimes Parts can last for years and other...

Your radio code can be retrieved directly from Honda. The code will need to be installed to restore radio function. You may need to contact your local Honda dealer if the radio does not accept the code provided by Honda....

The ABS light coming indicates a fault in the ABS system. Fault codes should be read out as this will guide the diagnosis. Possible causes for the ABS light coming on and off is a possible loss in wheel speed...

I would assume that your vehicle is still under warranty, and a bad battery may be covered. I recommend checking with the dealership you bought the car at. If you aren't having any trouble starting your car and it is...

Hi there. I would have the tires rotated to see if the problem changes. If it does, then was a tire that was warped or worn unevenly. The problem is that balancing can be off depending on where you get...

You would use a bolt-out spiral fluted socket. A common example of this tool is the Craftsman 10 pc. Damaged Bolt/Nut Remover Set Low Profile Bolt-Out (Item # 00952166000P Model # 52166). However, Irwin makes a set as well and...

Hi there. On the VTEC engine, there are several different electrical connections that would have to be upgraded in order for it to fit correctly. But, for the same year, I believe the motor mounts are in the same location...

You will need to start by draining all the fuel and put in new fuel and then see if it starts or the pump and filter assembly may be bad.

Engine misfires can be caused by many different problems and are generally caused by either a spark or fuel issue or in some cases, a combination of both. Spark related problems generally will result from things like ignition coils, crankshaft...

The fuel level sensors on some of these vehicles tend to be misread by the computer, causing faults in the system. The fuel sensor would need to be inspected, and the engine computer scanned, to see if the codes received...

Hello. The symptoms you are describing are commonly associated with a problem with the heater core or blend door actuator. If the heater core is plugged or there is not sufficient coolant flow to the core then the heating capacity...

Hello. There are aftermarket alternators on the market that you should check the internet for kits for this vehicle so you can install the larger amp. You may find that this large of an amp may require a second battery...

Prior to honing, the cylinder has to be measured for any out-of-round condition. The service limit on out-of-round for your specific engine is .0005 inches. If out-of-round exceeds .0005 inches, which it probably does, the block has to be serviced...