Popular questions

Question
If I change the battery on a 2008 Acura RDX will I need to do anything besides swap out battery?
There is a lot of memory lost when you change the battery. The radio might need to be re-coded and the power windows and sun roof may not work correctly until you do a re-set. The car may also not...
Question
Car stalls after longer trips
Hello there, thank you for asking about your 1988 Chevrolet Celebrity. There are numerous potential causes for your problem. One thing that comes to mind, however, is the ignition module. These are known for being problematic on your vehicle. The...
Question
The VVT solenoid
Hello. It may be possible to access the solenoid from within the motor, however that would require disassembly of the engine, or at least the valve train. You may be able to access it by removing the valve cover. Regards,...
Question
ECU and related components
Your ECU would have to be programmed. Although it is possible nowadays for consumers to download the software from the OEM for a fee, you need an interface cable and knowledge of the programming steps. Once you add up the...
Question
Why is my 2007 FORD 500 accelerates when I turn the steering wheel in the Drive or Reverse unintentionally and make the car jumps
You should have the computer tested for codes and then have the steering checked to see if there is a steering or engine issue with idle since it is normal for the engine to increase the idle when it senses...
Question
Carb not getting enough fuel I don't see it in the window n I put new fuel pump n lines on and another carb on it but same proble
Hi there. Unfortunately, I think Jay is correct here. Usually when you see air bubbles in the filter, it's due to a pick-up issue or debris in the fuel. If the gas tank is the original one from 1980, it...
Question
My car has a code P0342 replaced twice now won't start
You may need to check the wiring harness that runs to the camshaft position sensor as it may be faulty or have a poor connection resulting in the sensor not providing an accurate signal to the computer, which would cause...
Question
Car will not move in gear after we bleed the clutch slave cylinder 2011 Dodge Caliber
Hello - if releasing the clutch pedal with the car in gear does not produce forward motion with the transmission in a forward gear, then yes, the clutch has likely failed. This would be a failure of the clutch disk...
Question
Inside edge of tires wearing out too fast
There is a technical bulletin from the manufacture to check the alignment camber, and if the camber is out of specification, replace the right rear lower control arm to correct the alignment. As far as the other tires, you should...
Question
Car shudders and idles low - 1992 Toyota Cressida
It is possible that this is a misfire condition either due to a faulty ignition system component or fuel injector that is creating a power imbalance that will cause a shudder sensation. The fuel system and ignition system should be...
Question
Peugeot 206 won't start.
Hi there. I would check to be sure the engine is getting fuel, air, and spark. If the Check Engine Light is on, I would recommend having it hooked up to a scanning tool to see what trouble codes have...
Question
Need to replace the driver's side mirror
On many vehicles, the door panel does not need to be removed to replace the side mirror. The mirror usually has a small trim piece to cover up the mounting nuts on the interior side of the door. If you...
Question
Chrysler 300 C 2012.... battery saver mode
If there is an unusual odor (you refer to a burning odor), I would not drive the car. Other than the odor issue, based on what you are describing you are not going to worsen the situation. A particular concern,...
Question
noise after oil change
Hello. If this occurs right after the oil change it is because the vehicle was put up in the air to service it. When this occurs the bushings and shocks over extend, which ends up putting them in the wrong...
Question
How do I remove crank arm from wiper motor
It is possible to loosen the nut, but it can be difficult, and usually takes some skill and patience. Depending on your skill level, this may or may not be something that you want to attempt. When nuts like...
Question
Brake pedal feels hard
It sounds as though you may have a brake hose that has collapsed inside. There are three flexible hydraulic hoses on your car that allow the brake lines to move with the wheels. There are two on the front and...
Question
cracked oil pan
Hello. It is possible that the service shop doesn’t know exactly what is leaking or where the leak is coming from. When there is a leak that is hard to detect, sometimes a technician will introduce dye into the oil,...
Question
Front wheel rumbling/rattling noise at consistent speed
Hi there. In all honestly, the symptoms you are describing can be multiple sources, from wheel bearings (as the initial mechanic thought) to warped brake rotor, excessive wear on CV joints, or transmission components. It's also possible that a drive...
Question
Idles rough and when accelerating takes time to build up speed
Hi Paul. It certainly appears you've covered most of the bases in regards to tracking down a misfire. However, the problem with a flood or excessive water (like you've explained) is that quite often, electrical harnesses will become damaged and...