Hi there - your mechanic was being straight with you. The fuel filter is attached to the fuel tank on the S. African models, with a seal in between the filter and tank. Getting a proper fit on re-assembly in...
This is a classic noise when brakes are due to be serviced. The fact that you only hear it at low speeds only means it isn't very loud as of yet. The brake dust on the rear wheels is normal...
When an engine is cold, it needs to have rich fuel condition to run. Only when the engine has warmed up can it run at full power and efficiency. The thermostat not only keeps your motor from overheating, but it...
Hello there, thank you for asking about your Saturn. Check to see if you have fuel getting to the spark plugs. When you replaced the old plugs after cranking the car, were they wet with fuel? If so, then you...
It is possible that the quality of the rubber in the bushings for the shocks could not be as good as what the original shocks had. When bushings rub against the both that secures them to the vehicle this can...
Hello and thanks for contacting YourMechanic. Intake gaskets will seal, however, it is recommended to add some RTV (room temperature vulcanization) silicone to the gasket to seal it on the heads. I recommend using the blue water resistant RTV sealant...
There is not much of a break in period needed for your vehicle. But, there are a few things you can do to ensure that you start your vehicle working properly. To break in your vehicle. Do not drive...
A professional with Saturn experience should use a scan tool to check for diagnostic trouble codes in your transmission control module. Some repairs can be made without a complete disassembly of the transmission. This will help him or her make...
Hi there - unfortunately, this is not a service YourMechanic.com offers at this time. This task is best handled by a collision repair estimator at a reputable paint and body shop. S/he is trained to evaluate visible and not-so-visible damage,...
I would suggest calling a locksmith and explain the problem that you have to see if they have the capability to help you out. Unfortunately, I do not think they can but it will not hurt to give them a...
This is likely a charging system problem (i.e. alternator or voltage regulator). As you may know, the alternator is responsible for charging the battery while the engine runs by generating amperage and recharging the battery while the engine turns the...
It is not clear if only the remote start feature is not working or the engine won't start use conventional, in car starting as well. If just the remote start function is not working, the problem is likely in the...
Hello. I hate to say that this is a common problem, and there really is not alternative way of fixing it. When the top mount wears out, this will occur causing the steering to bind. The only way to fix...
Interpreting OBD codes is not always a case if replacing the part mentioned in the code. In most cases the code will indicate a circuit (in this case oil temp sensor circuit) and a voltage (voltage high or voltage low)....
The solenoid can be tested. Other possible causes of failure to shift out of 1st gear are low fluid level, faults in the throttle position sensor, vehicle speed sensor, slipping band and so forth. If it is the original transmission,...
If your vehicle is slowing down all by itself or having trouble accelerating, it is possible that the brake calipers on the front of the vehicle are locking up. This will cause the brakes to be applied at all times....
Hi there. There should be a select button with two directional arrows on the button. Push and hold the right directional arrow on the button and the dash should go from the odometer to the menu. Then scroll up by...
Hi there. That's very odd for a dealer repair to leave their shop with error lights appearing on your dashboard. The lights you've indicated are all related to either recommended service (the wrench) or the traction control system (squiggly lines...
The belt tension pulley may have lost a bolt that holds it in place may of fell out or left loose. You say you put on the new belt but still have issues with charge light and power steering. You...
It is possible that this could be normal depending on how severe the noise is. I would recommend taking the vehicle back to the place that you bought it and explain the situation to them. If there is an issue...
In a case like this it's difficult to estimate the damage without getting an inspection. What probably started as a bad wheel bearing became a whole lot more complicated when it was driven until failure, and it will be necessary...
When it comes to oil leaks, if your car is typical, there is probably more than one leak point. Without pre-cleaning the engine, it is possible to put a fluorescent dye into the engine oil, run the engine, and then...
