Q: where is the crank sensor located on a 1997 geo metro 4 cyl 1.3
where is the crank sensor located on a 1997 geo metro 1.3 4cyl motor, tryin to help a friend !!
My car has 98000 miles.
My car has an automatic transmission.
The crankshaft sensor is located on bottom right fron of motor near crankshaft pulley.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Car smoking and won't go into reverse without stalling.
I would ask for help from a mechanic to check the code that is turning on the check engine light. (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) The code in the computer will give the mechanic a starting point for his diagnosis. There are many reasons...
Idle set to low
It is possible that the idle may need to be readjusted so your car will run correctly. I would have one of the mechanics at YourMechanic inspect your vehicle's idle (https://www.yourmechanic.com/services/car-idle-is-rough-inspection) to see if there is anything that needs to...
How do I know I have two resonators? Can I have two mufflers in each side with one resonator? Which side is most important? Thank You.
You may have a single small resonator in the middle of the car that splits to the two mufflers. One on each side with single or dual tip outlets. The two mufflers are equal to each other to exit the...
Do you think clutch can burn out within a year of the car being manufactured? How could this happen? Thank you.
Hi There, 8,000 miles on a burnt clutch is certainly a premature failure of the clutch. While there are many reasons this may have happened, getting Audi to warranty this may be a different battle and will be something you...
Hello, I just got a 2001 Montaro Sport and I went to get in tonight and it started squealing. What cold it be?
The noise could be the serpentine belt (https://www.yourmechanic.com/services/serpentine-drive-belt-replacement) slipping due to age or the tensioner not holding the belt tight on the pulleys. Also an idler pulley could have a failed bearing causing the noise. Try removing the serpentine belt...
automatic transmission works fine in reverse, 1st, and 2nd, but revs the engine in 3rd 4th 5th only goes 30mph
You could have a defective vehicle speed sensor, transmission shift solenoids, transmission control module, valve body in transmission, throttle position sensor and/or the interconnecting wiring, fuses, and terminals (involving the electrical components) could have a defect. Another possibility is an...
2017 mercedes e300 with 17K miles shakes while idling with AC on. Why?
This is normal when the AC is on. The air conditioning compressor requires torque from the belt system on the engine to power it. When the AC is off, the compressor clutch does not activate, meaning the AC is not...
Camaro Halo Ring some of the leds are out, but not all
Hi Ryan. Thanks for contacting us today. Typically, this indicates an individual bulb issue. However, it is also possible that a part of the wiring harness or connection is not secure or an electrical short exists. I would start by...
Related articles
Is It Unsafe to Continue Driving a Vehicle with Broken Wheel Speed Sensors?
Car wheel speed sensors are an important safety feature. It helps the ABS system work when you need to make an emergency stop.
How to Replace an ABS Speed Sensor
The Anti-Lock Braking System uses speed sensors to make sure your wheels are synced when braking. Most modern cars are equipped with this sensor.
How to Replace a Wheel Speed Sensor
A car wheel speed sensor helps control the anti-lock brake system by determining if a wheel is moving at a different speed than the other wheels.
Browse other content
Cities
Maintenance