Q: When my car comes to a complete stop, the rpm dial moves up a little, then comes down, and it makes a soft rumbling sound-at low s

This code means that there is a configuration problem with your instrument cluster module. This could mean that the instrument cluster module was not reprogrammed after installation. I would contact the shop where you had the work done and ask...

Most likely the problem is with the ignition cylinder. These fail quite regularly on vehicles like yours. A trained technician, such as one from YourMechanic, will be able to inspect and repair your ignition (https://www.yourmechanic.com/services/ignition-key-is-stuck-and-does-not-turn-inspection).

Hello, if the shifter is disconnected, there is a chance that what ever holds the cable to the linkage is broken or worn out. The cable where it has become disconnected should be inspected to see what has failed. I...

Hello. The existence of so many non-functioning items would seem to indicate that a main control fuse, and junction box, are not working. Check to see if there are any electrical components that may have been disturbed during the timing...

First thing you want to do on a Civic is check the valve lash. Check the adjustment for the mechanically adjustable valves. If the valves are off adjustment on Hondas they will do exactly what you are describing. The other...

Hello. If the PCV system is not hooked up correctly, this will cause excessive oil burning. This needs to be checked and repaired first. If the PCV system (https://www.yourmechanic.com/services/positive-crankcase-ventilation-pcv-valve-replacement) is working then the issue is more than likely the piston...

Hello there, thanks for writing in. I'd be happy to help. If you replaced the sensor twice and the issue persists, then I would look at the connector and ECM as possible sources of the issue. I would carefully inspect...

Yes, you can replace a wheel bearing (https://www.yourmechanic.com/services/wheel-bearings-replacement) that is pressed in, however this usually requires a hydraulic press n order to remove and replace the bearing. Alternatively, you may remove the hub and take it to a machine shop...

This is something that is likely related to what is called a neutral safety switch, which prevents the vehicle from being started while in gear. Your vehicle has a neutral safety switch (https://www.yourmechanic.com/services/neutral-safety-switch-replacement) that will prevent the vehicle from starting...