Q: Trucks starts up but have to give gas to keep running then dies starts up a second time then it will stay running.

asked by on

Trucks starts up but have to give gas to keep running check engine light flashes then dies. Start it up second time then it will stay running.

My car has 132000 miles.
My car has an automatic transmission.

It sounds like you may have a dirty or failing idle air control valve. The idle air control valve monitors the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at idle. This valve is controlled by the vehicle’s computer and will adjust idle speed based upon other measurements such as engine temperature, intake air temperature and electrical system load or voltage. This is also an important function when starting the motor as it allows the motor to run and idle on it’s own once the motor fires. When you accelerate, the engine RPM increases, and as you let off the gas, the RPM slowly returns to the normal idling speed with the help of the idle air control valve making the transition from a higher RPM back down to idle speed while adjusting the air/fuel ratio constantly to allow this to happen smoothly. When the engine RPM drops below the normal range of about ~800 RPM, this often times will cause the engine to stall indicating a dirty or faulty idle air control valve. I would recommend having an expert from YourMechanic come to your location to diagnose and inspect your vehicle.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Trucks starts up but have to give gas to keep running then dies starts up a second time then it will stay running.

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Starting problems, starter failure - 1994 Suzuki Sidekick

Hello. Make sure you double check to see if the starter is getting good connections and the cables are good. You may just have a starter that is common to only last a few years before wearing out. Make sure...

Q: Shuddering shaking from take off through 1st and 2nd gear. What can cause this? I just bought the car and I'm scared I was ripped.

This is often a sign of low transmission fluid or a faulty transmission control solenoid. As you know, automatic transmissions use pressurized hydraulic fluid to change gears. Every time a gear change is required, the car's computer activates a transmission...

Q: Can a leaking intake manifold cause surging on my 93 Chevy Silverado 1500

Hello. A leaking intake manifold gasket can definitely cause the vehicle to run like this. It will not only cause excessive amounts of air to enter the engine, but it will also cause the sensors to not read right. It...

Related articles

How Long Does a Heater Control Valve Last?
Keeping the right amount of coolant in a car is essential in keeping the engine at the right temperature. Failing to have the right amount of coolant or even bad elements...
P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.