Q: Sunroof not closing.

asked by on January 14, 2016

My sunroof won't close.

Electrical components are not working Inspection $94.99 - $114.99 Get a Quote

There is a way to manually close the sunroof in your vehicle. There should be cover next to the sunroof button, that when removed, has a button for manually closing the sunroof. The details of how to do this can be found in your owner’s manual. This method is good for emergency situations. To fix the sunroof permanently, I suggest getting assistance from a professional technician, such as one from YourMechanic.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Sky slider not closing properly
The sky slider feature not closing properly on your Jeep Liberty is actually not an uncommon problem. There is actually a technical service bulletin that informs certified mechanics on the proper fix for this exact problem. In most cases this...
Power steering is hard, softens when I accelerate
Well given the symptoms, it sounds like the power steering pump is not putting out adequate pressure. When you replaced the power steering pump, did you use an OEM pump? If not, I would suggest having the power steering pressure...
What would cause brand new O2 sensors to give codes 172, 173, 176, and 177, rich and lean conditions, both sides at the same time?
When it comes to across-the-board codes being set such as this, it is usually a result of something "upstream" creating the condition to set all these codes. For instance, it is rare for both O2 sensors to fail at exactly...
Vehicle failing to pull, smoking black
Hello. If the vehicle is struggling when traveling up inclines then it may be possible that there is issue related to the engine, or possibly transmission. Black smoke is produced when the engine is unable to properly burn all of...
I can't turn off my hazard lights in my Mazda 3 - help!
Hello, thank you for writing in. There is likely something wrong with the hazard switch itself. The power is always available to the switch while off or on for safety reasons. They are wired to work under any condition if...
Can I use the ignition switch from a 1992 GMC pickup fora 1973 camaro
No. They have a different connector pin layout and connector.
Transmission was replaced but not set in right so it won't bolt down believe it's disk between motor and transmission
The problem sounds like the transmission torque convertor is not inserted all the way into the transmission. If you try and force it you will damage the transmission. You need to spin and push in the torque convertor until it...

Related articles

The Best Used Cars to Buy If You're a Construction Worker
If If you're a construction worker, you don’t have to worry about hauling a whole lot of supplies and materials to the site – that’s the boss’s problem. As long as it’s big enough to hold your tools (and most...
Top Five Selling Cars in Colorado in 2012
Colorado Colorado offers a varied climate depending on where drivers are located. Those in lower elevations see plenty of sunshine all year, while those in the mountain areas can see as much as 300 inches of snow. Due to this,...
The Top 5 Selling Cars in Delaware in 2012
Delaware Delaware offers a variety of weather, which means drivers have to be prepared for both the mild and the treacherous. In previous years, the best-selling vehicles have included the Honda Civic, Accord and CR-V, along with the Toyota Camry....