Skip the auto shop - Our mechanics make house calls

Q: Power window problem

asked by on

The power window isn't working.

Hello! I believe that the issue you are having is caused by a faulty window regulator. It is a fairly common part failure on your particular vehicle. I suggest that a knowledgable technician, such as one from YourMechanic, test the operation of your window regulator. If the regulator is deemed to be "OK" there may be an issue with a fuse, the window switch, or the power supply being delivered to the window. A faulty window regulator is the leading cause of window malfunction.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Front End Thumping Noise

Hi there: At first glance, I'd believe this noise is caused either by faulty wheel bearings or perhaps a warped brake rotor. However, it is very difficult to duplicate a road noise issue inside a shop or on a rack....

Q: After replacing the window regulator in my 2002 Ford Windstar the window goes up crooked.

Hi there. The window regulator is loose or the window is off the window regulator causing the window to go up crooked. Remove the door panel and check the window regulator and see if it's not mounted properly. If the...

Q: the bolt size at the top fixed chain guide 2.2 ecotec

Hello. The timing chain guide bolts on this engine are an M6 x 1.00 30mm. You will need to remove the rest of the broken bolt from the engine prior to replacing these. The replacements are available over the internet...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.