Q: My motorcycle exhaust smells like strong gas

I learned to drive on a standard transmission. It is not that hard to drive a modern standard transmission, because hydraulic clutches run smooth, and the shift is on the floor. It’s not like when I was a kid, when...

Hi there. Check the wiring from the fuel pump relay to the computer and see if there is a break in the wire. If there is no break in the wire, then check the power to the pin where the...

If the vehicle will not start after a timing belt replacement (https://www.yourmechanic.com/services/timing-belt-replacement), it is very likely that the replacement did not get performed to specification and the engine is out of time. This would require the engine to be disassembled...

If you are getting a noise from the rear end when you put pressure on it by giving it gas then the cause is going to be the ring and pinion bearings most likely. Have the pinion bearing checked where...

This is likely as your symptoms do fall into that category because a clogged or malfunctioning idle air control valve may not allow enough air into the engine to maintain a good idle speed. A faulty air temperature and engine...

It sounds like you may possibly have a brake pad (https://www.yourmechanic.com/services/brake-pads-replacement) that may have come apart resulting in the metal chunks being dispersed in between the [brake rotor(https://www.yourmechanic.com/services/brake-rotor-disc-replacement) and the backing plate. I would suggest having a professional from YourMechanic...

This is normal for the clutch release arm to move side to side as it is in a ball joint and needs to pivot. As long as clutch is releasing properly now you should not have any worries.

OBD-II trouble codes, including all codes that refer to oxygen sensors, do not constitute a diagnostic or identification of specific failed parts. Consequently, you cannot use the codes as the sole basis to replace vehicle parts. Codes are clues only....