Q: My engine was move and it just cut off when started it want turn over

Your dash is information central – gauges and warning lights provide you with a great deal of important information. If your Charging System light comes on (it looks like a little battery), it means there’s something wrong. It should come...

If the engine was running prior to replacing the sensors then you may have a faulty sensor. It is common for this to occur. If it was running the same prior to this then you may have another problem. The...

The radiator fan consists of the fan motor powered by the fan relay in the engine compartment relay box. The cooling fan relay is controlled by the fan control module behind the glove box. This control module will turn on...

Hello there, a few common faults would cause your 1971 Chevrolet El Camino to stall out like this. The most common would be the carburetor (https://www.yourmechanic.com/services/carburetor-replacement), battery (https://www.yourmechanic.com/services/battery-replacement), alternator (https://www.yourmechanic.com/services/alternator-replacement) or the fuel pump (https://www.yourmechanic.com/services/fuel-pump-replacement). I recommend having a qualified...

You may have a dirty or failing idle air control valve. The idle air control valve reads the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at idle. Since...

The full body kit is designed for the RX-7 from 1993 to 2002 models. Your model of the R2 and the kits model of FD3S is the same design only a little different to accommodate for an engine with dual...

Hi There, It sounds like your car is shutting down or going into a "safe mode" as a result of the motor overheating. The computer is designed to shut the car down like this in the event that it detects...

Hi there. The best advice we can offer here is for you to search online for a service and repair module for your 2010 Hyundai. It has much more detailed information about completing this service than we can offer on...

Yes, you are absolutely on the right track but to complete the diagnostic job you will need the complete circuit diagram (Factory Service Manual, for instance) because you will have to test all the different segments of the circuit until...