Q: My care hesitated to accelerate, i backed it up and it put 3 times and shut off. Now it cranks and wont start. I put in new spark

The auto-up and auto-down features allow you to entirely roll up or down a power window with one press of a button. Sometimes the auto-up and auto-down functions stop working, and need to be reactivated. To do this, pull the...

The elapsed time feature displays how much time has elapsed since the last feature reset. You can reset the elapsed time with just two steps: Press the display button on the lower left side of the instrument panel until the...

This code is a sign that the engine did not get to operating temperature in a specified amount of time and the computer turns on the Check Engine Light. The most common problem is that the engine thermostat is partly...

When you put pressure in the radiator you are only going up to about 15 psi, but when a cylinder fires, it puts out a lot more than the compression test showed at 125 psi. This is why you are...

Hello, thanks for writing in about your 2000 Chrysler Cirrus. The transmission control module would need to be scanned to see if the codes stored may indicate the shifting problem you are having. You may have an internal shift solenoid...

Hi there. The first step is to check for any problem codes (https://www.yourmechanic.com/article/how-to-read-and-understand-check-engine-light-codes-by-jason-unrau) stored by engine management. This can save a lot of time money when diagnosing drive-ability problems. Most auto parts stores will do this for free. Several problems...

Hi there - your symptoms describe possible worn strut bearing plates (https://www.yourmechanic.com/question/new-gas-struts-installed-groaning-noise-like-rubber-on-metal-can-or-should-you-grease-them-by-adam-h), or a power steering rack that is worn. Both tend to "creak' a bit more during cold weather. I recommend a " steering & suspension inspection](https://www.yourmechanic.com/services/brakes-steering-and-suspension-inspection) performed by...

Hello, thank you for writing in. With the check engine light on, we need to start by scanning the vehicle for diagnostic codes to find out why that light is on. We can use the codes to help point us...

You may have caused the theft system to lock out the start circuit. Try to close and lock the car and come back in an hour and unlock and try to restart the car. If still no start then you...