Q: Master cylinder push rod loose

asked by on February 12, 2016

The master cylinder push rod came loose from the clutch pedal.

Clutch is not working Inspection $79.99 - $99.99 Get a Quote

If the push rod came loose from the clutch pedal, it may be possible that the retaining pin simply slipped out, or the push rod is broken. I would recommend having a professional technician, such as one from YourMechanic, examine the clutch pedal assembly, to determine the exact cause of the problem.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

Rear right tire wont turn

Hi There, You may have one of a couple of different issues going on here. You may possibly have a stuck brake caliper not allowing the wheel to turn or potentially a seized wheel bearing. Generally a wheel bearing will...

My clutch engages but my truck is still hard to get into gear 2003 Mazda B2300

Hi. It sounds like you are having a problem with the clutch hydraulic system. If the clutch appears to be engaging and not slipping then the hydraulic system is not fully disengaging the clutch which makes it hard to change...

Why does the heater blow hot air for a short time and then blow cold air?

It sounds like you may have a low coolant level. There may not be enough coolant to reach the heater core to provide you with hot air in the car. A visual check of the coolant level while the vehicle...

Car broke down won't start does a fast clicking sound when trying to crank

The rapid clicking sound is definitely a problem with the battery. From the description of the failure, this certainly could be an alternator failure. Disconnecting the negative cable does confirm the alternator is not charging. The reason you don't find...

I recently replaced the radiator and thermostat and bled the lines now my car is overheating and I'm trying to find out if it's th

You should be able see the fluid circulating with the cap off. Begin with a cool engine, take the cap off and allow the engine to warm up to normal temperature. When the thermostat opens, you should be able to...

My car is stuttering as I drive

If you are continuously filling up the oil, and see no signs of a leak, then the engine is consuming the oil. This can happen two ways. The oil can seep into the combustion chambers, or can be burned on...

Guage, fuel and thermostat needles moving very fast

You may have a connection that is getting corroded and is causing intermittent connection problems. If the problem happens again then have the connection to the dashboard cluster disconnected and then add dielectric lube to connection and pins. At the...

car won't start chugs

It's possible that your Saturn SC2 has a broken timing belt. That will make it sound strange when it's cranking and will not start. You can listen back by the gas tank and try to hear if the fuel pump...

My car's engine is overheating, what could be the cause?

An overheating engine can be caused by several components. A new thermostat is a great place to start, and knowing that it is not the problem we can focus elsewhere. If the thermostat was suspected, then you may have another...

Related articles

Symptoms of a Bad or Failing Fan Clutch
If your car has a fan clutch, common signs include the vehicle overheating, the cooling fans working very loudly, or engine performance decreasing.
How to Determine Compression Ratio
Whether Whether you’re building a new engine and you need the metric, or you’re curious to know how efficient your car uses fuel, you have to be able to calculate the engine’s compression ratio. There are a few equations needed...
How to Bleed a Clutch
A clutch master cylinder contains a reservoir with brake fluid. It is connected to the clutch slave cylinder through hoses. When you...