Q: Just had cluster replaced on a 2005 Ford freestyle. Filled up tank and a day later was driving car fuel tank light came on

First, check to make sure there is an adequate amount of fluid in your power steering reservoir (https://www.yourmechanic.com/services/power-steering-fluid-service). If it is low, top off the fluid and have the system checked for leaks. If the pump still makes noise when...

The two code are for two different issues and if both codes were not fixed, or after the repairs the engine self learn was not reset, then the light may come back on and the car not run correctly. I...

Hello. Code P0089 is the code for an issue withe the vehicle's fuel pressure regulator. In this instance it appears that the code refers the fuel pressure regulator mounted in the engine bay, on the vehicle's high pressure fuel pump....

The most likely cause of the hard start (https://www.yourmechanic.com/services/car-is-hard-to-start-inspection) after getting fuel is going to be a leaking fuel vapor purge valve. The leaking purge valve would allow the fumes that build up in the fuel tank while refueling to...

Hi there. The transmission weights around 125 to 150 lbs and may weigh additional 125 pounds if there is a transfer case attached to it. The transmission overall length is around 3.4 feet depending on the type of output shaft...

Unfortunately, yourmechanic.com does not do engine replacement or engine swaps. We would not have any helpful information for that. However, I personally have seen both a 370Z and G37 Coupe both with Chevy LS-3 engine swaps. Your best bet would...

Hi there. Thanks for writing into YourMechanic.com. You are correct in assuming that all four tires should be the same on an all-wheel drive vehicle. However, with less than 5,000 miles on the new tires, it would be OK to...

Hi there. Usually when a car will stall all of the sudden without warning, it's caused by a restriction of fuel or an electrical glitch with the ignition system. If you've had the throttle position sensor changed, and fuel pump,...

The grinding noise may be a number of things, but is often times associated with the a starter that is beginning to fail. When this happens, sometimes the starter gear that engages the flywheel remains engaged too long resulting in...