Q: Is 750 Nm a lot for a 2 L engine?
Tuytf
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
How do I get the passenger airbag sensor to recognize the passenger?
The passenger airbag sensor determines when there is a person in the passenger seat. When the sensor determines that there is a person I the passenger seat, the passenger airbag will be turned on. However, sometimes the passenger airbag sensor...
Low Tire Pressure light is on
You need to reset your TPMS system. This is done through the controls on your steering column. Consult your vehicle owners manual or look for a simple "how to" video such as this one here (https://www.youtube.com/watch?v=VrpC4tZ8bZI). If the system still...
Bad oil pressure sensor
A common failure in your vehicle is the oil pressure sending unit. Once the sensor is replaced, these codes should go away. I would ask for help from one of the mechanics at YourMechanic to replace your oil pressure sensor...
Steering wheel hard to turn in 2002 Chrysler PT Cruiser
Hi there. If it is hard to turn in either direction, then it may have a bad power steering pump. I typically start by checking the engine belt and the fluid in the reservoir. If these items are fine then...
After i installed new front brakes, they started squeaking..............whats the problem?
Hi there, thanks for writing in. I'll be glad to help you with your question about brake noise on your 2005 Montana. Shims and high temperature grease must be used in this application, otherwise noise may occur. It is also...
Loud chatter at idle only
Hello, thanks for writing in. If the flexplate was changed within the last year, then I would usually start by isolating that area of the noise. This noise can occur if the bolts are coming loose. If they are fine...
Inconsistent RPM. It is too high majority of the time
Hi there. If a high idle is the concern a sticking idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) or a vacuum leak could be the problem. Has anyone attempted an idle adjustment? If so, reset it back to the factory position. Listen...
The power steering locks up
Hi there. It sounds like there could be a belt, pulley, or accessory problem. One of these items could be causing your steering concern and the smoke. Are there any visible leaks from the power steering pump? Any leaks from...
My key is stuck in ignition starts but won't turn back into lock position to remove the key.
The problem is most likely caused by a bad shift cable end not getting it all the way to the park position to allow key to turn all the way off. Have this cable checked at the transmission shift lever...
Related articles
How to Buy a Good Quality Gasket
There There are a wide variety of gasket types on a typical vehicle, from head gaskets which are installed between the cylinder head and the engine block to engine gaskets which seal out harmful elements and keep the engine safe...
How to Measure the Torque (Twisting Power) of Your Car
Torque is proportional to horsepower and varies depending on the car and its specific features. Wheel size and gear ratio both affect torque.
How to Calculate Horsepower
Horsepower determines how fast an engine can propel a car. Find out how to calculate horsepower for different types of cars and engines.
Browse other content
Services
Cities
Estimates