Q: Low Tire Pressure light is on

asked by on February 03, 2016

My Low Tire Pressure light is on, but I have checked the tires and the pressures are all okay.

You need to reset your TPMS system. This is done through the controls on your steering column. Consult your vehicle owners manual or look for a simple "how to" video such as this one here. If the system still will not reset, you may have a problem with one or more of the tire pressure sensors. If you need assistance, a qualified mechanic can inspect and repair your tire sensors.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

How does power steering affect a car’s handling?
When considering the effects of power steering on a vehicle's handling it is important to realize that there are several types of power steering systems used in today's automobiles. While most vehicles in the past used a type of steering...
Trouble starting, misfires, dies when you let off the gas.
It sounds like you have a real bad vacuum leak (https://www.yourmechanic.com/article/is-it-safe-to-drive-with-a-vacuum-leak). After you replaced the radiator and hoses to get it running again check all the vacuum hoses to make sure there is no broke hose. If you find there...
Knocking when starting from a cold start
This is somewhat normal as the oil sits down in the oil pan when the car has sat for an extended period of time. When you first start it in the morning, it takes a bit of time for the...
I have a gas leak from the gas tank area - 2000 GMC Sierra 1500
As you know, a gas leak can be extremely dangerous depending on the specific location of the leak and the proximity to hot parts, such as exhaust. I would recommend having an expert, such as one from YourMechanic come to...
Blower motor not blowing air
Hello, thank you for writing in. You have to replace the resistor because it was likely the cause of the melting wire. You have to replace that wire as well. Often replacement wires are not the same color. As long...
So I need a special tool to remove a knock sensor on a 2005 Buick LaCrosse
An ordinary 6 point socket is used to replace the knock sensor on this model. Stalling, if that is what you mean by "cutting off", is not typically caused by a faulty knock sensor. Unless the knock sensor has been...
Rattling and shaking in front underneath my jeep? Then it rattles when turning feels off balance
The rattling noise is indicative of loose or worn parts, probably in suspension components. The causes of the shaking depend on what speed this is occurring at. If at high speed, shaking could be due to wheel imbalance and/or a...
ball joints
Vibration felt through the steering wheel at high speeds is often due to tire imbalance/tire defects although worn suspension components can be a contributing factor. If ball joints have failed early, there are only a handful of possible explanations for...

Related articles

Understanding Tire Service Descriptions: Speed Rating and Load Index
There There never seems to be a shortage of questions you are asked when you inquire about tires. What size do you need? What speed rating do you require? How will you be using them? What load index do you...
4 Essential Things to Know About Your Car’s Tire Pressure Gauge
The The tire pressure gauge is a sensor that reads the tire pressure of all four tires of a vehicle. Modern vehicles have a Tire Pressure Monitoring System (TPMS) built in. Starting in 2007, the TPMS has to report an...
How to Buy Good Quality Tires
When When it comes to parts that are important on your vehicle, it’s hard to find something that is more important than your tires. Good tires make a massive difference, not just in bad weather, but even good weather too....