Q: I just had my spark plugs changed and it was driving fine until the third day i noticed that the rpm is above a 1 and when at a

The menu system in your car’s satellite radio helps you navigate through channels, categories and more. Using it is easy, too. Here’s how: Turn the key on. Turn the audio system on. Press the SIRIUS button. Press the menu button...

There can really be several reasons why your Ford Bronco II randomly turns off. While the information provided is a bit limited, I do have a good idea on where we can start. You are on the right track to...

The carburetor needs a good supply of fuel to keep the engine running; if the fuel pump is not suppling the fuel, or the filter is clogged solid, then fuel cannot get to the carburetor. If fuel is getting to...

Hello, thanks for writing in. Most of the time, this code comes up when there is a difference between the crank and cam sensors. The most common failure is the crankshaft position sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-crankshaft-position-sensor). These fail much more frequently (https://www.yourmechanic.com/article/how-long-does-a-crankshaft-position-sensor-last)...

The signals you get in your car simply warn you to turn the engine off when the oil and coolant are too low, but will not shut the car off on it's own. When the oil pressure switch detects low...

Hello. Adding brake fluid to the system was a great idea. Although it did not turn off the ABS light (https://www.yourmechanic.com/services/abs-light-is-on-inspection), you can use that to your advantage. The light means the computer is detecting a problem, and you can...

Hi there. Removing a muffler is illegal on vehicles with gasoline engines that need to pass emissions in counties that suppress the emissions law. For counties that do not enforce the emission law, meaning there is no emission testing required,...

The repair information from Chrysler says an OEM level scan tool must be used to update the mileage and VIN number in the replacement PCM. If this is not done, a diagnostic trouble code (DTC) will be set. You'll want...

Generally this is something caused by the flasher relay (https://www.yourmechanic.com/services/hazard-turn-signal-flasher-replacement) going bad. This is a small relay that allows the lights to flash based upon current flow and a resistor inside that causes them to flash. When this is faulty,...