Q: I had the water pump replaced due to a leak. What would cause the engine to overheat now?

asked by on

just replaced the water pump on my acadia because it was leaking. Now that it has been replaced it is over heating now and coolant level is good. bled out cooling system was thorough too. what would be the problem.

My car has 230000 miles.
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. I had the water pump replaced due to a leak. What would cause the engine to overheat now?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Where is the yaw rate sensor located?

Hello, thanks for writing in about your Toyota Sequoia. The yaw sensor is located below the center console. It's mounted to the floor at the rear of the console. The console needs to be removed in order to replace it....

Q: I have a 2013 cadillac xts. The ac stopped blowing cold air a couple years ago and all i had to do was turn it off for five minute

There are innumerable things that can go wrong with the A/C system and so the best thing to do is request an air conditioning system inspection and the responding certified mechanic will get this resolved for you. The possibilities that...

Q: Coolant leak sprayed everywhere

Hello. More than likely, the hose clamps are loose or they are not in the right position. This would cause coolant to spray everywhere. It may also be necessary to replace the hose clamps you have now with new ones....

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.