Q: How much cost to fix ignition switch? 2008 Dodge Sprinter

Starting the engine is simple, even though the ignition on your car might be slightly different from what you’re used to using. Here’s how: Make sure you have the Intelligent Key with you. Push the brake pedal. Make sure the...

If the battery will not hold a charge (https://www.yourmechanic.com/services/battery-will-not-hold-a-charge-inspection), then it may be bad or has a draw on it causing the drain. I recommend having the battery checked to see if the battery has a draw. Check to make...

There are many different reasons for the Transmission Service Light to come on for your 2004 Jaguar Vanden Plas. The most common would be low fluid level (https://www.yourmechanic.com/services/transmission-fluid-service) or a fluid service interval (https://www.yourmechanic.com/article/how-long-does-transmission-fluid-last) that has been exceeded. If you...

Hello, thanks for writing in about your Oldsmobile Aurora. A bad starter solenoid could make the starter run, but would not activate the ignition switch, so the engine could crank but not run on its own. I would recommend testing...

Hi there. It is very rare that these two circuits affect each other. It can be a failure in the SAM module if both of these problems started at the same time, but most of the time they are separate....

Hello. The hard start and O2 sensor light can be due to the fuel control distributor leaking excessive amounts of fuel from the air control door. Some leakage is normal but less that 22cc of fuel and anymore than this...

Hi and thanks for your question. It sounds like you have two different things that could be fixed. There is either a vacuum line that split open on the blend doors to the heater and a/c system, or the blend...

Hi there. From the description you have provided, it leads me to believe there is a charging system problem. Apparently, the battery is being run down while driving (https://www.yourmechanic.com/services/battery-is-dead-inspection). A good battery will recover on its own when it sits...

Hi Cassandra: I will try to help you. For safety reasons, the steering gear leak should be repaired first. After that the priority would be the replacement of the axles and then repair of the crankshaft seal leak. Technically, you...