Q: How do I use the power folding mirrors?

This is a common failure on your vehicle. Typically this occurs because the torque converter bolts come loose, or if the transmission was ever removed and the bolts were not torqued properly this will happen. The only way to repair...

Hi. It sounds like there was a small leak in the system that has turned into a bigger one, and now the system can't hold any pressure at all. Typically, there will be puddles of hydraulic fluid leaking from the...

You should have the engine scanned for codes first to see if there is a code to diagnose for no fuel pressure. The fuel pump will not run if the inertia switch is tripped. Look behind the right passenger side...

Without additional information regarding symptoms, this would be very difficult to diagnose. It's not very clear what is happening in this situation. Is the RPM not increasing during idle (https://www.yourmechanic.com/services/car-idle-is-rough-inspection)? is the tachometer (https://www.yourmechanic.com/article/3-essential-things-to-know-about-your-car-s-tachometer) not increasing as your car moves?...

Check the fuse for the heater/AC blower motor (https://www.yourmechanic.com/services/heater-blower-motor-replacement). If the fuse is good, then either the blower motor resistor or the blower motor itself is suspect. The blower motor resistor provides for multiple speeds for the blower motor. A...

Hello there, a variety of faults that can cause your 2001 Honda Civic to overheat (https://www.yourmechanic.com/article/can-a-car-battery-overheat-in-hot-weather). Your vehicle has two cooling fans, one is for the AC, the other is for the radiator. When the engine reaches operating temperature both...

Hey there. The problem sounds like the front brake pads have worn down to metal and now the brake pad has worn to the point it came out of the caliper bracket causing the pedal to drop. You should not...

Hi there - your car radio is equipped with a security code mechanism to deter radio theft - a bigger problem in 1994 than today. The Owners Manual should have the code (4 or 5 digit number) written in it...

Bob: Thanks for your inquiry. Oil level and oil pressure are measured using separate sensing systems. If the level sensing feature stopped working at the time the pan gasket was replaced, either the level sensor was damaged, not reconnected, or...