Q: How do I enable the autolamp control?

asked by on

How do I enable the autolamp control?

The Autolamp Control on your truck can make turning on your headlights easier. The Autolamp Control turns your headlights on automatically when it senses darkness. To enable Auto Lamp Control.

  1. Turn the Headlamp Control knob to the fourth spot.

  2. Turn the Headlamp Control knob to the beginning spot to turn off Auto Lamp Control.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. How do I enable the autolamp control?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: My car is running rough after changing the spark plugs and wires.

Hey there, the first thing to check are any trouble codes, even though this is pre-OBD II (Ford MCU or EEC-Iv engine management systems), there are inexpensive code readers for these engines, or your local parts store can read the...

Q: I want to upgrade my headlights.

If this is a serious consideration of yours I would look in your owners manual or contact your local dealership first for any information regarding the headlights that you can get. Some vehicles do not accept aftermarket modifications as well...

Q: Q: Where are the accessory power sockets located?

Need to plug in your cell phone charger? Want to connect an aftermarket GPS unit? No problem – there are two accessory power sockets in your Accord. Lift the small lid on the left side of the center...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...