Q: Getting the wheel bearings done

asked by on June 30, 2016

I was told there are two bearings and a seal that has to be replace since the truck is a 4.0 Eddie Bauer ford explorer 2003. Will the quote reflect this or is it something that has to be added in? The quote i done only stated the price for one bearing....

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

What does the anti-lock brake system (ABS) Warning Light mean?
The anti-lock brake system (ABS) Warning Light is located on the instrument panel. This light illuminates when your ABS is not operating properly. Since your ABS is a key part of your brake system, you should have your vehicle inspected...
My car won't start
Try to replace the battery and clean the battery terminals (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-battery-terminal-ends) first. It is also possible your Jeep has a defective totally integrated power module (TIPM). This module powers everything to do with starting and running the vehicle. The noise...
Engine
You should go with the same motor you had originally. If not you will run into fit problems and computer issues with the sensors after you try to start it. There will be less problems by going with same motor...
It turns over but won't start. And if it starts, it dies out. When it starts, the pressure gauge goes way above 60
Since you mentioned that the motor will eventually start at times, we can assume that it is getting spark. This means that you may have a fuel delivery issue. This may happen due to lack of fuel pressure, a faulty...
Ignition lock cylinder
The only other way to get the ignition lock cylinder out you would have to drill it out. Then the lock insides can be removed so you can replace the lock cylinder. Make sure to not use over a 1/2...
What could be causing the serious vibrations in the steering column and front end when the truck exceeds 35 mph?
Hello, thank you for writing in. The most common issues with vibrations at higher speeds are related to the tires or suspension. The first place to start is having the tires inspected. Make sure the tread is deep enough, the...
Inner tie rod with tool cant remove
In order to remove the inner tie rods you have to use a tool to bend back the lock tabs that hold it locked in place. Once the lock tab is bent back then the remover tool can loosen the...
2000 Saab 9-3 SE. Can just the Throttle Position Sensor be replaced. Got error code P1230... I cleared it and car drives normally.
Hi There, These codes indicate that the signal from the throttle position sensor (https://www.yourmechanic.com/services/throttle-position-sensor-replacement) is weak or inconsistent. You do not need to replace the entire throttle body and should be able to fix this by replacing the throttle position...
Why won't my car start after replacing fuel pump
Hi there. In general, when an engine just 'clicks' when you turn the key, it's due to an electrical relay that is damaged, battery or battery cables that are worn out or broken or a broken fuse. Any or many...

Related articles

A Buyer’s Guide to the 2012 Ford Flex
The The 2012 Ford Flex takes on a completely different look when it comes to a CUV. The Flex can tow up to 4,500 pounds and seat seven passengers comfortably. It also has lots of standard features that its competitors...
The Best Used Cars to Buy for Highway Driving
Do Do you spend hours each week on the highway for work? Maybe you just live in a very rural area and have to drive for 30 or 45 minutes to get to the grocery store. Whatever the case, your...
Ford Certified Pre-Owned (CPO) Car Program
Drivers Drivers in the market for a used Ford vehicle may want to check out cars under their certified pre-owned program. Many manufacturers have a certified pre-owned (CPO) program, and each one is set up differently. Read on to learn...