Q: Dodge charger has18.3 avg for fuel

It’s important that you’re able to communicate things to other drivers – the intention to turn, for instance. When you go to turn your car from one road onto another, or into a driveway or parking lot, you use your...

You are most likely experiencing an engine misfire (https://www.yourmechanic.com/services/engine-is-misfiring-inspection). An engine misfire will cause a jerk, or hesitation sensation you are describing. The most common problems that cause misfires in your engine are the spark plugs, wires, or ignition coils....

It sounds like the hinge is worn out on the visor. You will probably need to get the part from the dealer. A certified technician can assist you with changing this out along with getting the part as well. It...

Just because the wheel has weights attached to it doesn't mean it is balanced correctly. My guess is that the wheels/tires are out of balance. However, the problem could also be worn steering/suspension parts or tires (https://www.yourmechanic.com/services/brakes-steering-and-suspension-inspection). A bent rim...

Any time a computer module is replaced it needs special programming (https://www.yourmechanic.com/article/what-is-a-reprogrammable-ecu) to work with your vehicles other modules and program it to start and run your engine. The programming for the ECU can only be done by a specialized...

Hi there. If only the high mounted light in the middle works, then there is a problem with the wiring to the rear lights. This is assuming that the bulbs are good. If the bulbs are fine then I usually...

Hello. The symptoms you describe can be caused by many things. If you are feeling a vibration when putting the vehicle into gear then it may be possible that there is a transmission or engine related issue. If the transmission...

At 2mm, the pads are definitely due for replacement. The the thickness of the brake rotors should be measured and compared to the minimum thickness specifications. If they measure above the specs and there is enough thickness to them, resurfacing...

The bearings in the alternator will probably become noisy prior to the electrical components going bad. So, if you value quietude, there may be an advantage to installing a new alternator prior to "complete" failure of the part. Apart from...