Q: Do u know where I can get a gear shift cable in philadelphia

A power window has several components, all of which will cause it to stop working. The switch, motor and the regulator. The switch is the button you press to make it go up and down. Since it is on the...

Hello, this is commonly caused by a failing thermostat. When the thermostat fails it will not allow the coolant to circulate causing the engine to get hot. I typically check the temperature of the radiator hoses to see if the...

This is probably something that needs to be looked at as soon as possible. Two likely causes could be the either an inner fender liner that is dragging in the tire or the plastic belly pan has either come loose...

This is true, but there are countless other reasons for an illuminated Check Engine Light (https://www.yourmechanic.com/article/what-does-the-check-engine-warning-light-mean) as well. A loose gas cap will typically set an evaporative emissions (EVAP) system code, such as P0440 (https://www.yourmechanic.com/article/p0440-obd-ii-trouble-code-evaporative-emission-control-system-malfunction-by-jay-safford_2) or P0455 (https://www.yourmechanic.com/article/p0455-obd-ii-trouble-code-system-gross-leak-evaporative-emission-by-john-nelson). The EVAP...

Although I cant fully diagnose this issue with the information provided, I can say that both of the O2 sensors (https://www.yourmechanic.com/services/oxygen-sensor-replacement) that are after the catalytic converters, should be stable under normal conditions. Your engine load at idle seems higher...

Hi there. This typically means that the fan itself has failed or there is a problem with the circuit. I usually start by checking for voltage supplied to the fan when the A/C is turned on. If there is voltage...

Hello. Trouble code P0016 (https://www.yourmechanic.com/article/p0016-obd-ii-trouble-code-camshaft-position-a-camshaft-position-correlation-bank-1-by-jay-safford) is set when the computer detects that there is an issue with the timing between the engine's camshaft and crankshaft signals. The camshaft and crankshafts are connected by a belt or chain, and are precisely...

The problem is that you had the brake rotors resurfaced and the pads were not replaced. The old pads surface was not flat when the rotor surface was resurfaced. The raised parts of the pads wore into the rotors first...

Hi there. There will be a bolt that is attached to a wedge that is holding the battery in place. The bolt will be next to the battery and the black box. You may have to remove the black box...