Q: Crankshaft position sensor. 2012 Chrysler 200

asked by on

How do you remove a crankshaft position sensor for this car. What has to be removed to get to the position sensor?

A: Hey there. The crank sensor is at the rear ...

Hey there. The crank sensor is at the rear of the motor. You have to remove the heat shield to get access to the sensor. If you need assistance with this repair, an expert technician from YourMechanic can come to your car's location to replace the crankshaft sensor for you.

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Save up to 30%

Get a quote

What others are asking

Q: My car will not start, cranks but doesn't run.

sent to CS. answer also made live.

Q: Problem starting car and dies while driving

This sounds like it could be a faulty crankshaft sensor or a camshaft sensor. These engines had problems with both. The hard start and the backfire may be the camshaft sensor. The stall and no start condition may be from...

Q: 2012 chrysler 200 won't start after replacing alternator which was bad after testing.

Hi there. It sounds like something may have shorted during the alternator replacement. If the positive cable going to the alternator made contact with anything metal, then it may have blown the main fuse. If not, then the battery should...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the P0052 code means This code is seen when the Engine Control Module (ECM) tries to control the...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.