Skip the auto shop - Our mechanics make house calls

Q: Clutch not disengaging

asked by on

I recently replaced the clutch pedal, clutch, and transmission. The clutch pedal does not seem like it is disengaging the clutch after the vehicle has warmed up.

A: You likely need to bleed the pressure out o...

You likely need to bleed the pressure out of the hydraulic system. Improper installation could also have caused the problems. I would have a certified mechanic, such as one from YourMechanic, inspect your clutch issue and make the needed repairs needed to have this issue resolved.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Headlight problem and car getting stuck in 2nd gear in sports mode.

A bad ballast for the low beam headlights is a common problem for your vehicle. The problem of getting stuck in second gear will require an experienced technician with special diagnostic equipment to see if the problem is with the...

Q: RPMs issue - 2012 Hyundai Veloster

Hello. This sounds like your clutch is slipping. Check the transmission clutch to see it is slipping and needs to have the clutch replaced. If you would like to have this looked at for you, an expert technician from YourMechanic...

Q: Marker lights not working

Hey there. It is possible that a fuse blew when the new light was installed with the vehicle in the on position. I would recommend checking the marker light fuse to determine if it has blown. It is always best...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
How Long Does a Heater Control Valve Last?
Keeping the right amount of coolant in a car is essential in keeping the engine at the right temperature. Failing to have the right amount of coolant or even bad elements...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...