Q: 2010 automatic toyota rav4 wont shift to reverse

asked by on

Car still runs but wont shift to reverse gear

My car has 90000 miles.
My car has an automatic transmission.

If your transmission will not get reverse gear then you may have an internal reverse clutch band worn out or the apply solenoid is not coming on and would need to have transmission pressures and codes checked to isolate the problem.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. 2010 automatic toyota rav4 wont shift to reverse

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Leaving stop light car runs high rpms 5000-6000 and doesn't want to go over 20 mph 2009 Chevy Traverse

Hi there - first thing to check is the transmission fluid level - low fluid levels can cause lots of problems like this - your transmission is obviously slipping badly. If the fluid is at a correct level, and doesn't...

Q: When do the vehicle stability control and traction control systems operate?

Your vehicle is equipped with both a vehicle stability control system (VCS) and a traction control system (TRAC). They operate independent of your input – they come on and off automatically, without you having to do anything. They will automatically...

Q: 2010 dodge avenger saying hotoil where the grears are supposed to be. If you drive it it dissapears and engine light turns on.

If the check engine light is on, then trouble codes have been stored. Even if the light goes off, the codes are still stored in memory and with an appropriate scan tool, the mechanic will read the codes. To get...

Related articles

Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.